Mcua Indicators - Huawei S9300 Hardware Description

Quidway S9300 Terabit Routing Switch
Hardware Description
Indicator/Button
ACT
RST
SYNC

7.4 MCUA Indicators

This section describes the MCU indicators.
Table 7-5
Table 7-5 Description of the MCU indicators
Indicator/Button
RUN/ALM
Issue 02 (2012-04-30)
Color
Green
-
Green
describes the MCU indicators.
Color
Green
Red
Orange
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Meaning
This indicator shows whether the SRU is the
master SRU or slave SRU.
If the indicator is on, it indicates that the SRU
is the master SRU.
If the indicator is off, it indicates that the SRU
is the standby SRU.
Press this button to reset the board.
NOTE
Resetting the board will cause the loss of service
packets. Confirm the operation before you press the
Reset button.
If the indicator is on, it indicates that the
device supports the time and clock
synchronization and the clock board is
installed on the SRU.
If the indicator is off, it indicates that the
device supports the time and clock
synchronization but the clock board is not
installed on the SRU.
Description
If the indicator is on, it indicates that the MCU
is powered on, and the software is not run.
If the indicator blinks every 2s (0.5 Hz), it
indicates that the system is in normal state.
If the indicator blinks every 0.25s (4 Hz), it
indicates that the system is starting.
If the indicator is in red, it indicates that the
board is faulty.
If the indicator is in orange, it indicates that
the board is inserted in the subrack and is
installed, and the board is powered on.
7 List of Indicators
196