Advertisement
Addition Mode
•
In Addition mode new inputs are added to the total counted, not resetting with
each new input.
•
To turn on Addition mode, press the 'ADD' button until the Addition light turns on.
•
To turn Addition mode off, simply press the 'ADD' button once again. The light will
turn off.
Batching mode
•
In batching mode the counter can sort money together into pre-set values.
•
Press the 'BATCH' button on the device, the display will show 100 / 50 / 20 / 10.
•
For the latest Australian currency notes, ensure the transparent strip in the middle
of the note (Fig 5) does not pass through the IR sensors of the unit (Fig 6), as this
may cause the device to display error codes or an inaccurate note count.
Advanced operation:
Fake Note Counting
•
To turn Fake Note Counting on, hold the Decrease (–) button for at least 3 seconds
until the display screen shows 'U-01'.
•
To turn it off again, briefly press the Decrease (–) button again until the display
screen shows U-00.
•
Let the device run to save your changes.
Double Note Recognition
•
Double-note recognition alerts when two bills have been fed simultaneously.
•
To increase the sensitivity in detecting double-notes, hold the 'BATCH' button for at
least 3 seconds until the display screen shows 'E' followed by a number (ie, 'E-05').
•
The default sensitivity setting is E-05, however this can be adjusted by pressing the
Increase (+) button or Decrease (–) button. The total range is E-00 to E-20. A higher
number represents higher sensitivity for double-note detection.
•
Press the 'RESTART' button to save your changes.
Fig 5
IR Sensors
Fig 6
Advertisement
