Advertisement
Quick Links
Instruction manual
Airbrush Compressor AS20W
with Vacuum Pump
34202
Illustration similar, may vary depending on model
Please read and follow the operating instructions and safety information prior to initial operation.
Technical changes reserved!
Illustrations, functional steps and technical data may deviate insignificantly due to continuous further
developments.
Advertisement
Related Manuals for WilTec AS20W
Summary of Contents for WilTec AS20W
- Page 1 Instruction manual Airbrush Compressor AS20W with Vacuum Pump 34202 Illustration similar, may vary depending on model Please read and follow the operating instructions and safety information prior to initial operation. Technical changes reserved! Illustrations, functional steps and technical data may deviate insignificantly due to continuous further...
- Page 2 The information contained in this document may alter at any time without prior notice. No part of this document may be copied or otherwise duplicated without prior written consent. All rights reserved. WilTec Wildanger Technik GmbH cannot be held liable for any possible mistakes in this operating man- ual, nor in the diagrams and illustrations shown.
- Page 3 Store the compressor in a well-ventilated place. • Always wear protective goggles. Under no circumstances should you direct the airflow towards your body or other persons’ bodies or animals. © by WilTec Wildanger Technik GmbH Item 34202 Page 3 http://www.WilTec.de http://www.aoyue.eu...
- Page 4 Protection against excessive temperature • Very low noise level Field of application • The AS20W airbrush compressor is e.g. suitable for operating in the following areas: ◦ crafts, ◦ hobby, ◦ modelling, ◦ tattoos and body art, ◦ make-up and nail design, ◦...
- Page 5 On the outlet of the compressor, there is a lower pressure; the pressure that you actually work with remains. The operating pressure may vary according to the connected airbrush gun. © by WilTec Wildanger Technik GmbH Item 34202 Page 5 http://www.WilTec.de...
- Page 6 Water release needle Retainer ring Capacitor Compression ring On/off switch – Wire – Rubber pad Cylinder Hexagon head nut Valve plate Connection Valve Connector ring Screw Pressure controller © by WilTec Wildanger Technik GmbH Item 34202 Page 6 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 7 German law related to electrical and electronic equipment and appliances. All WilTec electric devices that fall under the WEEE directive are labelled with the symbol of a crossed- out wheeled rubbish bin. This symbol indicates that this electric device must not be disposed of with the domestic waste.