Advertisement
10
Make wire connections to power source using
wire nuts provided. Make sure that no filiments
are outside of the wirenut. After making the
wire connections, the wires should be spread
apart with the grounded conductor and the
equipment-grounding conductor on one side of
the outlet box and ungrounded conductor on
the other side of the outlet box.
13
Loosen one and remove one pre-
assembled screw from mounting
bracket. Save screw. Lift canopy up,
aligning its keyhole slot with the pre-
assembled screw on mounting
bracket and twist clockwise to lock in
place. Re-install the removed screw
and tighten all screws securely.
16
Check the motor for plastic shipping stabilizer
tabs, and remove them if they are present.
Attach blade assembly to motor using the
motor screws and washers provided. Tighten
screws securely.
© 2011 Monte Carlo Fan Company
11
House
Black
White
Green
For pullchain controls, follow diagram above.
Make sure that all exposed wiring is secured
inside wire nuts. Note: Wires from house may
vary in color and may not include ground wire.
After wiring is conplete, gently push wires into
junction box with wire nuts pointing upward.
Refer to point 3 of safety tips.
14
Place blade bracket onto blade by aligning the
3 holes on blade as shown.
17
After installation of all blades you must replace
the rubber grommet to ensure no water leak-
age through to switch housing.
4
12
Fan
Black
Blue
White
Green(downrod)
Green(Bracket)
For control of fan and optional light from wall
location, follow diagram above. NOTE: A profes-
sional electrician is recommended for this type
of installation.
15
Install 3 screws and washers per blade and
tighten securely. Repeat for all 5 blades
Reverse switch
Install switch cap into switch plate hous-
ing, align the 3 holes and install 3 screws
and tighten securely. Setting the
reverse switch in the left hand side
will result in downward airflow and
setting the switch in the right hand
side will result in upward airflow.
Wall
Control
2/8/2012
Advertisement
