Filter Cartridge / Door Inner Surface; Maintenance And Cleaning; Water Tank - Saivod STE73C Manual

5

Maintenance and cleaning

Filter Cartridge / Door Inner Surface

Lint and fibres released from the laundry to the air during
the drying cycle are collected in the "Filter Cartridge".
C
Such fibre and lint are generally formed during
wearing and washing.
C
Always clean the filter and the inner surfaces of the
cover after each drying process.
C
You can clean the filter and filter area by vacuum
cleaner.
To clean the filter:
1. Open the loading door.
2. Remove the cover filter by pulling it up and open the
filter.
3. Clean lint, fibre, and cotton raveling by hand or with a
soft piece of cloth.
4. Close the filter and place it back into its
seat.
C
Clogging may arise on the filter surface after using
your machine for some time; if this occurs, wash the
filter with water and dry it before using again.
C
Clean the entire inner surface of the cover and door
gasket.
Sensor
There are humidity sensors in your dryer that detect
whether the laundry is dry or not.
To clean the sensor:
1. Open the loading door of the dryer.
2. Allow the machine to cool down if drying has been
carried out.
3. Wipe the metal sensors with a soft cloth, dampened
with vinegar and dry them.
C
Clean metal sensors 4 times a year.
A
Never use solvents, cleaning agents or similar
substances when cleaning since these materials can
cause fire and explosion!

Water tank;

The moisture in the damp laundry is taken from the
laundry and condens ed. Drain the water tank after each
drying cycle or during drying when "Water tank" warning
light turns on.
A
Condensed water is not drinkable!
A
Never take out the water tank when the programme is
running!
If you forget to drain the water tank, your dryer will stop
during the following drying cycles when the water tank
is full and the "Water tank" warning light will turn on. If
16 EN