Preparing The Window - Haier ESA405N User & Care Manual

ENGLISH

PREPARING THE WINDOW

1. Measure the width of the window opening. (See Fig.13)
2. M a k r the center line on the inside of the windowsill
with a pencil. (See Fig.14)
WIDTH OF
WINDOW OPENING
NOTES AND WARNINGS:
Be sure your air conditioner does not fall out of the window opening during
or removal.
• Do not block the air discharge or air intake areas on the front panel.
• o D not block the louvers on the outside of the air conditioner.
3. C e t n r e the air conditioner in the window sill.
Make sure to place the unit so that it is resting on the
windowsill with a ¼" to ½" downward tilt towards the
outside. Lower the window sash behind the top channel
to hold the unit in place. (See Fig.15)
NOTE: The appearance of your model may differ from the
one shown.
4. Loosen the screw located on the lower-right hand corner
of the air conditioner.
5. S d i l e the side bracket over the screw. The side bracket
should be resting on the window sill. (See Fig.16)
6. Partially tighten the screw. Secure the unit before tightening completely.
7. U e s 1/8" drill bit to drill a starter hole through the holes in the side
bracket into the window sill.
8. U s n i g two (2) 1" wood screws, attach the side bracket to the
window sill.
9. Repeat for side bracket installation on the left-hand side of the air
conditioner.
PAGE 12
WIDTH
HOW TO INSTALL
CENTER LINE
CENTER
Top Channel
Lower Window Sash