Table of Contents
Advertisement
3. Set the desired time by pressing the
Time Delay key. Each press on the key
will increase up to 9 hours with 3-hour
increments.
4. Close the door of your machine after
setting the Time Delay. Once the delay
time is over, the selected programme
will start automatically.
The time delay will start countdown
with the closing of the door after
selecting the Time Delay function.
If the door is opened while the Time
Delay function is active, the countdown
will be paused and start icon will start
to flash.
Changing the settings while Time
Delay function is active
While the Time Delay function is activated,
you cannot make changes in the washing
programme, auxiliary functions or the
duration of time delay.
Auxiliary functions cannot be set after
the programme has started.
To cancel the time delay function
To cancel the process while the Time Delay
function is active the programme should be
canceled.
Time delay function cannot be set after
the programme has started.
Starting the programme
Close the door of your machine to start it
after selecting the programme and auxiliary
functions.
Your machine performs water softening
depending on the hardness level of
the mains water. Washing time can
change while the programme is running
depending on the ambient temperature
where your machine is installed,
temperature of the supply water and
amount of the dishes.
Pay attention not to open the door of
the machine when it is running. There
may be a rush of vapour when you
open the door of your machine; be
careful.
After the rinsing step the machine
will wait silent in pause mode for
some time in order to have the water
remaining in the machine and on the
dishes drained completely and to have
the water softener cleaned, and then it
will resume running in drying mode.
Cancelling the programme
Press and hold the Programme Selection
/ Programme Cancel keys for 3 seconds.
Release the key as the Start indicator starts
flashing.
Once you close the door of your machine,
draining is completed in 2 minutes
and the machine gives an audible warning
when it is completed.
There might be residues of detergent
or rinse aid left in the machine and/or
on the pieces being washed depending
on the step in which the programme
has been cancelled.
Salt Indicator (
Please check the salt indicator on the
display to see whether there is adequate
amount of softening salt in the dishwasher
or not. You need to refill the salt reservoir
with salt whenever salt indicator appears
on the display of your machine.
Adjusting the water hardness level is
explained in Water Softening System
section.
)
33/EN
Hide quick links:
Advertisement
Table of Contents
