Makita DBO380 Instruction Manual page 9

7. Maintain a proper tension on abrasive paper, and
then set the clamp lever on the other end in a locked
position.
2 3
1
Fig.7
► 1. Abrasive paper 2. Clamp 3. Sanding base
4. Clamp lever 5. Stopper
8. To remove the abrasive paper, release the clamps
on both ends and take the paper off the pad.
Using abrasive paper available in the
market
1. Cut a sheet of abrasive paper down to an appro-
priate size.
1
2
Fig.8
► 1. Abrasive paper 2. Pad
2. Push and hold down the clamp lever on either front
or rear end of the pad, and slide it away from the stopper
so the clamp is released from its fastened position.
3. Pull the clamp lever outwards as far as possible to cre-
ate a space between the clamp and side wall of the sanding
base in which one end of abrasive paper can be inserted.
4.
Slip one end of the abrasive paper into the space
between the clamp and sanding base.
3
2
1
5
4
5. Reposition the abrasive paper so it is finely over-
laid on the pad surface.
6.
Set the clamp lever back in a locked position to
clamp the end of abrasive paper securely.
7. Release the clamp on the other end, and have the
other end of abrasive paper ready to be clamped.
8. Maintain a proper tension on abrasive paper, and
then set the clamp lever on the other end in a locked
position.
5
4
2 3
1
Fig.9
► 1. Abrasive paper 2. Clamp 3. Sanding base
4. Clamp lever 5. Stopper
9. Cover the abrasive paper with the punch plate
with its positioning stoppers adjacent to the corner well
fit onto two of the side edges of the pad and sanding
base.
2
1
Fig.10
► 1. Abrasive paper 2. Punch plate 3. Positioning
stoppers 4. Pad 5. Sanding base
10. Push the punch plate over the abrasive paper to
make dust-suction holes.
11. To remove the abrasive paper, release the clamps
on both ends and take the paper off the pad.
9 ENGLISH
5
4
4 5
3
5
4
3
2
1
5
4
3