Table of Contents
Advertisement
Control Surface Operation
Function Keys
The function keys F1 to F4 (25) are provided for future
expansion of user programmable commands.
Their default configuration, within the HUI
implementation, is as follows:
● F1
Clear overload flag in audio channels
● F2
Recall screenset 2
● F3
Recall screenset 3
● F4
Recall screenset 4
Please consult your Logic manual, and Logic Control Surfaces
Support document, to learn about modifying these key
commands within your host software.
Console SETUP
The SETUP switch (2) allows you to access a number of useful
networking parameters, set the host DAW platform and check
your current firmware revision.
Editing Setup Parameters
To edit parameters, rotate the corresponding rotary encoder
to change the value - the SETUP LED flashes to indicate the
change.
Press the SETUP switch to confirm and apply the changes.
The SETUP LED returns to a solid red once changes are
confirmed.
24
protocol and Logic
TM
Press SETUP and the OLED
displays will show the first page of
the setup menu.
To change page, use the page
keys (26) located under the left
most encoder.
The first five SETUP pages are described in more detail during
the network setup procedure on page 6:
Page 1 – Host Software
Page 2 – Use DHCP (networking option)
Page 3 – IP Address (networking option)
Page 4 – Subnet Mask (networking option)
Page 5 – Port (networking option)
Page 6 – Factory Reset
Press down on the rotary encoder to reset the console to its
factory default settings.
Note that this will reset the analogue main channel
levels and motorised faders to "off".
Pages 7 & 8 – Serial Number & Firmware Info
These pages are for information purposes only.
Control 2802 Logic Pro Automation & Control Surface Manual
Advertisement
Table of Contents
