DeWalt DCG412 Instruction Manual page 68

< 50% charged
Pack needs to be charged
To actuate the fuel gauge, press and hold the fuel gauge button (P). A
combination of the three green LED lights will illuminate designating the
level of charge left. When the level of charge in the battery is below the
usable limit, the fuel gauge will not illuminate and the battery will need
to be recharged.
FIG. 7
P
NOTE: The fuel gauge is only an indication of the charge left on the
battery pack. It does not indicate tool functionality and is subject to
variation based on product components, temperature and end-user
application.
For more information regarding fuel gauge battery packs, please contact
your local service center.
Switch
LOCK-OFF BUTTON AND TRIGGER SWITCH (FIG. 8)
Your grinder is equipped with a lock-off button (B).
To lock the trigger switch (A), press the lock-off button as shown in
Figure 8. When the lock-off button is depressed to the lock icon, the
unit is locked.
Always lock the trigger switch when carrying or storing the tool to eliminate
unintentional starting.
To unlock the trigger switch, press the lock-off button. When the lock-off
button is depressed to the unlock icon, the unit is unlocked. The lock-
off button is colored red to indicate when the switch is in its unlocked
position.
Pull the trigger switch (A) to turn the motor ON. Releasing the trigger
switch turns the motor OFF.
FIG. 8
B
LOCKED
NOTE: This tool has no provision to lock the switch in the ON position,
and should never be locked ON by any other means.
WARNING: Hold the side handle and body of the tool firmly to
maintain control of the tool at start up and during use and until the wheel
or accessory stops rotating. Make sure the wheel has come to a
complete stop be fore laying the tool down.
WARNING: Allow the tool to reach full speed before touching
tool to the work surface. Lift the tool from the work surface before
turning the tool off.
SPINDLE LOCK BUTTON (FIG. 2)
The spindle lock button (C) is provided to prevent the spindle from
rotating when installing or removing wheels. Operate the spindle lock
button only when the tool is turned off, the battery is removed, and the
wheel has come to a complete stop.
66
UNLOCKED
A