Advertisement
12 • ENGLISH
3. Engage the gun safety catch (20).
Restarting
1. Release the safety catch (20).
2. Depress the gun trigger and discharge the residual
air inside the hoses.
3. Set the starter device on (ON/I).
Storage
1. Switch the appliance off (OFF/0).
2. Remove the plug from the socket.
3. Turn off the water supply tap.
4. Discharge the residual pressure from the gun until
all the water has come out of the nozzle.
5. Drain and wash out the detergent tank at the end of
the working session. To wash out the tank, use clean
water instead of the detergent.
6. Engage the gun safety catch (20).
Recommended cleaning procedure
Dissolve dirt by applying the detergent mixed with water to
the surface while still dry.
When dealing with vertical surfaces work from the bottom
upwards. Leave the detergent to act for 1-2 minute but do
not allow the surface to dry. Starting from the bottom, use
the high pressure jet at a minimum distance of 30 cm. Do
not allow the rinse water to run onto unwashed surfaces.
In some cases, scrubbing with brushes is needed to
remove dirt. High pressure is not always the best solution
for good cleaning results, since it may damage some
surfaces. The finest adjustable nozzle jet setting or the
rotating nozzle should not be used on delicate or painted
parts, or on pressurised components (e.g. tyres, inflation
valves, etc.). Effective cleaning depends on both the
pressure and volume of the water used, to the same degree.
MAINTENANCE (Fig. E)
Any maintenance operations not covered by this chapter should
be carried out by an Authorized Sales and Service Centre.
¡Important! To ensure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(other than those listed in this manual) should be performed
by authorized service centers or other qualified organizations,
always using identical replacement parts. Unit contains no
user service able parts inside.
Caution! Always disconnect the plug from the power
socket before carrying out any work on the appliance.
Cleaning the nozzle
1. Disconnect the lance from the nozzle.
2. Remove any dirt deposits from the nozzle hole using
the tool (10).
Cleaning the filter
Inspect the intake filter (7) and detergent filter (if fitted)
before each use, and clean in accordance with the
instructions if necessary.
Unjamming the motor
In case of lengthy stoppages, limescale sediments may
cause the motor to seize. To unjam the motor, turn the
drive shaft with a tool.
End-of-season storage
Treat the appliance with non-corrosive, non-toxic antifreeze
and lubricate the o-rings using the lubricating grease tube
(where supplied) as shown before storing it away for winter.
Put the appliance in a dry place, protected from frost.
PROTECTING THE ENVIRONMENT
Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your
BLACK+DECKER product needs replacement,
or if it is of no further use to you, do not dispose
of it with household waste. Make this product
available for separate collection.
Separate collection of used products and
packaging allows materials to be recycled and
used again. Re-use of recycled materials helps
prevent environmental pollution and reduces the
demand for raw materials. Local regulations may
provide for separate collection of electrical products
from the household, at municipal waste sites or by
the retailer when you purchase a new product.
SERVICE INFORMATION
Black + Decker offers a full network of company-owned
and authorized service locations throughtout Asia. All
Black + Decker Service Centers are staffed with trained
personnel to provide customers with efficient and reliable
product service.
Whether you need technical advice, repair, or genuine
factory replacement parts, contact the Black + Decker
location nearest to you.
NOTE
f Black + Decker's policy is one of continuous
improvement to our products and, as such, we reserve
the right to change product specifications without prior
notice.
f Standard equipment and accessories may vary by
country.
(On models with this feature)
Advertisement
