Related Manuals for Daikin EKLN140A1
Summary of Contents for Daikin EKLN140A1
- Page 1 Installation manual Low sound enclosure Installation manual English Low sound enclosure EKLN140A1...
-
Page 2: Table Of Contents
▪ A subset of the latest technical data is available on the regional Daikin website (publicly accessible). Lag screw 6×50 ▪ The full set of latest technical data is available on the Daikin Business Portal (authentication required). Installation manual EKLN140A1 Low sound enclosure 4P650154-1A –... -
Page 3: About The Unit And Options
Installation MUST be carried out by an authorised installer. Rounded finishing 2 people are required to install the low sound enclosure. profile, big (1 m) WARNING The parts may have sharp edges. Wear cut-resistant work gloves during installation. EKLN140A1 Installation manual Low sound enclosure 4P650154-1A – 2021.04... -
Page 4: Preparing The Installation Site
3 Affix 1 strip of sealing tape (accessory C) to the bottom side of Make sure installation, servicing, maintenance and repair the base frame in the centre of the profile. comply with instructions from Daikin and with applicable legislation and are executed ONLY by authorised persons. Requirements relating to the installation Ensure a horizontal, level and stable base (a paved base or a wooden frame). -
Page 5: About Installing The Outdoor Unit
10 Click the support frame into the base frame using the grooves. ALWAYS follow the instructions in the installation manual and service manual of the outdoor unit for the related procedures to uninstall and reinstall the outdoor unit. EKLN140A1 Installation manual Low sound enclosure 4P650154-1A – 2021.04... -
Page 6: Wiring
4 Pull the pipes and electrical cables through. 5 Guide the pipes and electrical cables through the floor (base) entry point of the outdoor unit to prevent kinks in the pipes. Installation manual EKLN140A1 Low sound enclosure 4P650154-1A – 2021.04... -
Page 7: About Installing The Slats Frame
1 Tilt the mounting lips at the end of the slat so that they form a INFORMATION 90° angle with the slat. Tighten them hand-tight (tightening torque <5N∙m). 3 Fit the plastic guide pins (accessory M) to the bottom of the vertical support. EKLN140A1 Installation manual Low sound enclosure 4P650154-1A – 2021.04... -
Page 8: To Install The Intermediate Slats
1 Tilt the upper slats into the vertical supports. 2 Place the slat at the top over the vertical supports. 3 Slide the slat into the notches below in the vertical supports. Installation manual EKLN140A1 Low sound enclosure 4P650154-1A – 2021.04... -
Page 9: About Installing The Panels And Sealing Strips
(accessory M). ▪ To avoid the short circuit of the airflow, ALWAYS keep the slats openings free from debris and remove dirt such as leaves and snow. EKLN140A1 Installation manual Low sound enclosure 4P650154-1A – 2021.04... - Page 10 6 Maintenance INFORMATION For information on maintaining the outdoor unit, see the service manual for the respective outdoor unit. Installation manual EKLN140A1 Low sound enclosure 4P650154-1A – 2021.04...
- Page 12 4P650154-1 A 0000000Y 4P650154-1A 2021.04 Verantwortung für Energie und Umwelt...