About The Installation Of Cables - Hitachi L Series Service Manual

4-2. About the installation of cables

Please install the power cable and the push-button cable as follows.
( 1 ) Check whether the plug is 9P (for power supply) or 6P (for operation).
( 2 ) Push the plugs into the switch part as shown in the figure below.
* There will be a "clicking" sound when the plugs are pushed in.
( 3 ) Pull the plugs lightly to ensure it is fully connected.
( 4 ) Fix the cables as shown in the figure below.
Power plug (9P)
Operation plug (6P)
In case of L-type (single speed),
LS-type (single speed, single phase)
Insert the nut at the tip of the PB
wire into the corner hole of the
wire retainer and tighten the screw
to prevent its detachment.
In the case of LN-type (dual speed)
Insert the nut at the tip of the PB wire into the corner hole at
the bottom right of the cover and tighten the screw with the
cable stopper to prevent its detachment.
Cable stopper
PB wire
- 12 -
Nut
Screw
Screw
Wire retainer
PB wire
Nut
PB wire