Table of Contents
Advertisement
(5) Remove the one M5×12 screw, then remove the switch stand and the packing.
(6) Detach the 6P connector and the 9P connector from the inside (part P) of the main body.
Screw M5×12
Switch stand
( 7 ) Remove 4 screws (M6×16) and remove the housing and the rotor.
2. How to disassemble the brake
( 1 ) Disassemble by the same procedure mentioned up to step (4) of '1. Disassembly of the housing and the
rotor'.
( 2 ) Remove 4 screws (M6×12) and 4 cover washers, only the 4 M6×16 screws in case of LN-type, and
remove the cover B.
Cover washer (L, LS)
screw M6×16 (LN)
screw M6×16 (L, LS)
( 4 )
packing
( 2 )
Cover B
P
Rotor
Housing
( 6 )
- 16 -
6P, 9P
connectors
P
Screw M6×16
Advertisement
Table of Contents
