Alpine CDE-203BT Owner's Manual page 28

The display disappears from/does not appear
in the display window.
The dimmer is set to [DIMMER ON] (page
21).
The display disappears if you press and hold
(power).
– Press (power) on the unit until the display
appears.
The connectors are dirty (page 24).
The display/illumination flashes.
The power supply is not sufficient.
– Check that the car battery supplies enough
power to the unit. (The power requirement
is 12 V DC.)
The operation buttons do not function.
The disc will not eject.
Press and Number button 6 for more than 2
seconds to reset the unit.
The contents stored in memory are erased.
For your safety, do not reset the unit while you
are driving.
Radio reception
Stations cannot be received.
The sound is hampered by noises.
The connection is not correct.
– Check the connection of the car antenna
(aerial).
– If the auto antenna (aerial) will not extend,
check the connection of the power antenna
(aerial) control lead.
Preset tuning is not possible.
The broadcast signal is too weak.
65 MHz to 74 MHz in FM3 cannot be tuned in.
[AREA] is set to [EUROPE].
– Set [AREA] to [RUSSIA] (page 20).
RDS
RDS services cannot be received (when [AREA]
is set to [RUSSIA]).
FM3 is selected.
– Select FM1 or FM2.
RDS services are unavailable in the current
region.
28
-EN
The SEEK starts after a few seconds of
listening.
The station is non-TP or has weak signal.
– Deactivate TA (page 13).
No traffic announcements.
Activate TA (page 13).
The station does not broadcast any traffic
announcements despite being TP.
– Tune in another station.
PTY displays [- - - - - - - -].
The current station is not an RDS station.
RDS data has not been received.
The station does not specify the program type.
Program service name flashes.
There is no alternative frequency for the
current station.
– Press / while the program service
name is flashing. [PI SEEK] appears and the
unit starts searching for another frequency
with the same PI (program identification)
data.
CD playback
The disc does not play.
Defective or dirty disc.
The CD-R/CD-RW is not for audio use (page
23).
MP3/WMA/AAC files cannot be played.
The disc is incompatible with the MP3/WMA/
AAC format and version.
MP3/WMA/AAC files take longer to play than
others.
The following discs take a longer time to start
playback.
– A disc recorded with a complicated tree
structure.
– A disc recorded in Multi Session.
– A disc to which data can be added.
The sound skips.
Defective or dirty disc.