Subscribe to Our Youtube Channel
Related Manuals for Petsafe HBK11-12009
Summary of Contents for Petsafe HBK11-12009
- Page 1 Option 1 - Dog Kennel 10'(W) x 10'(L) x 6'(H) Model Number HBK11-12009 Option 2 - Dog Run 5'(W) x 15'(L) x 6'(H) 2-in-1 dog kennel assembly instructions PLEASE READ THIS ENTIRE GUIDE BEFORE ASSEMBLY...
- Page 2 • If your area is subject to heavy snow, it is recommended that you remove the SunBlock Top ™ during the winter months. Heavy snow can collapse the kennel resulting in damage and injury. • Kennel anchors are strongly recommended. PetSafe® Anchor Kit sold separately. 1-888-632-4453...
-
Page 3: Table Of Contents
To get the most protection out of your warranty, please register your product within 30 days at www.petsafe.net. By registering and keeping your receipt, you will enjoy the product’s full warranty and should you ever need to call the Customer Care Center, we will be able to help you faster. -
Page 4: Components
Spacer Gate Latch End Rail Clamps Tie Wires (12 pcs.) Tie Wires (4 Pieces) Assembly Insructions (100 pcs.) Tools Needed • Hammer • Adjustable Wrench • Pliers • Tape Measure Approximate assembly time: 1 hour Kennel installation help: www.petsafe.net/fence 1-888-632-4453... -
Page 5: Connect The Bottom Frame
Tube G to the top and bottom frame rails. For Option 1 – 10x10x6: use Tubes F and H together as shown in diagram. For Option 2 – 5x15x6: use Tube F as shown in diagram. Tube H will not be used. www.petsafe.net... -
Page 6: Install The Gate Post And Gate
• (8) Clips • (2) Gate Frame halves • (1) Gate Chainlink Fabric • (4) Tie Wires • (1) PetSafe Badge ® Assemble Gate Frame halves together. Slide tension bar into Chainlink and attach to one side of Gate Frame with 4 Clips. -
Page 7: Add Fence Fabric
Important: Be sure all tie wires are on the same picket (wire) or the fabric will be crooked. Stretch and tie to the next post, until you go all the way around. Don’t tie the last post (at the gate). www.petsafe.net... -
Page 8: Cut The Fabric
Cut the Fabric Step Gather (Quantity): Remove this picket • (5) Clips • (1) Tension rod " Stretch the fabric as tightly as possible to the corner post and select a fabric wire to cut, allowing 4 inches (10 cm) for the tension rod and clips (6A). -
Page 9: Getting Your Dog Comfortable In His Kennel
NOT rely solely upon the PetSafe 2-in-1 Dog Kennel to contain your pet. Radio Systems ®... -
Page 10: Terms Of Use And Limitation Of Liability
Terms of Use and Limitation of Liability 1. Terms of Use This Product is offered to you conditioned upon your acceptance without modification of the terms, conditions and notices contained herein. Usage of this Product implies acceptance of all such terms, conditions, and notices. 2. -
Page 11: Warranty
This Product has the benefit of a limited manufacturer’s warranty. Complete details of the warranty applicable to this Product and its terms can be found at www.petsafe.net. Australia/New Zealand - In compliance with the Australian Consumer Law, Warranties Against Defects, effective... - Page 12 Radio Systems Corporation ® 10427 PetSafe Way Knoxville, TN 37932 1-888-632-4453 www.petsafe.net 400-1653/3 ©Copyright 2013, Radio Systems Corpoation...
Need help?
Do you have a question about the HBK11-12009 and is the answer not in the manual?
Questions and answers