10. Do not use unit where aerosol-based products are being used, or where oxygen is being administered. 11. Unit is only meant to be used with recommended model PP230 accessories. Using other types of attachments may cause damage to unit or injury.
Page 3
If interference is suspected, the user is encouraged to contact Poulan Pro Consumer Service at 1-800-711-6617. SAVE THESE INSTRUCTIONS Questions or comments? •...
Product Information The following features and accessories are included with your Handheld Steam Cleaner. Carefully inspect the packing material for all parts listed below. To obtain possible missing parts, refer to Product Support on Page 12 of this manual for Consumer Service contact information. UNIT FEATURES Boiler Cap Steam Trigger...
Page 5
Product Information ACCESSORIES 5.5" Jet Nozzle 4" Triangle Brush 34" Extension Hose Fill Cup Storage Bag 1 - Round Brush 1 - 2.5" Round Scrub Pad 2 - 1.5" Nylon Utility Brush 2 - 1.5" Brass Utility Brush ENGLISH | 5...
Page 6
Assembling Your Handheld Steam Cleaner STEAM CLEANING ACCESSORIES WARNING: Do not connect accessories while unit is emitting steam. JET NOZZLE / EXTENSION HOSE / TRIANGLE BRUSH 1. Select one of the four accessories (Jet Nozzle shown as example) and push onto the Steam Nozzle (A).
Using Your Handheld Steam Cleaner FILLING THE BOILER 1. Place Handheld Steam Cleaner on a flat, level surface. 2. Make sure On/Off Switch is turned to “Off” and grounded power cord is unplugged from electri- cal outlet. If unit has been in use, always use the following safety precautions before removing the Boiler Cap to add water: •...
GENERAL OPERATION NOTE: Be sure that Boiler has been filled and that all desired accessories are connected before following these steps. 1. For first time use, remove protective plastic cover from electrical plug. Plug power cord into a electrical outlet. 2.
Storage & Care PROPER STORAGE Preparing your Handheld Steam Cleaner for storage is quick and simple. When you have fin- ished your steaming tasks, follow the steps listed below. 1. Turn unit “Off” and unplug power cord. 2. Press and hold Steam Trigger to release all remaining steam. 3.
Troubleshooting PROBLEM POSSIBLE CAUSE SOLUTION Unit fails to heat up. Unit is not plugged in. Household Plug power cord into electrical outlet. circuit breaker / ground fault inter- Reset circuit breaker / ground rupter has tripped or blown a fuse. fault interrupter, or replace fuse.
What is covered Poulan Pro® is a licensed brand of Steamfast, a division of Vornado Air, LLC (“Steamfast”). Subject to the terms and conditions of this 2-Year Limited Warranty (“Warranty”) as set forth below, Steamfast warrants to the original consumer or purchaser (“Buyer”) that this Poulan Pro®-branded steam product, excluding all accessories and attachments, (the...
Page 13
Warranty Information • Use of the Product other than for normal household purposes. • Normal wear and tear. • Used consumable parts, accessories and attachments, including, but not limited to, brushes, hangers, scrub pads and mop pads. • Use of parts and accessories other than those produced or recommended by Steamfast. •...
Page 14
Poulan Pro 415 East 13th, Andover, KS 67002 1-800-711-6617 poulanprosteam.com help@poulanprosteam.com T230-005 R-, V00...