Carrier Comfort TC-WHS01-BLK Installation Instructions Manual page 28

Hide thumbs Also See for Comfort TC-WHS01-BLK:

Table of Contents

Cool Dissipation Time The amount of time the fan will run after

the cool has been turned off. Running the fan for a period of time

allows for any cooled air left in the ducts to circulate throughout

the home. The time is adjustable from 0 to 900 seconds. The de-

fault value is 30 seconds.

Advanced Settings

Your Carrier thermostat is preconfigured for the most common system

type. The advanced settings and configuration options detailed in this

section are intended for professional installers only. Incorrect

configuration may lead to improper operation and equipment damage.

These options customize how long each stage will run before the next

stage turns on. You may also program when a particular stage is turned

on based on the temperature delta between the set temperature and the

current temperature.

Reverse Staging If enabled, the thermostat will cycle down from

the higher stages so that when it approaches set point it will only

be running in stage 1. The thermostat calculates which stage to

start the HVAC equipment in depending on the indoor tempera-

ture and set point temperature delta. The HVAC equipment will

start in stage 1. As the stage 1 temperature delta is exceeded, the

second stage will engage. Once the equipment has brought the

current temperature back to within the heat or cool differential

setting, stage 2 will disengage and stage 1 will remain running

until the set point is met.

Stage 2 Temp Delta The minimum difference between the cur-

rent temperature and the set temperature that will activate the

auxiliary heat (regardless if the maximum run time of the previ-

ous stage was reached). Options are Auto (default) and 1 to 10° F

(0.6 to 5.6° C).

Stage 1 Max Runtime The maximum amount of time stage 1

will run before engaging the next stage. Options are Auto (de-

fault) and 10 to 120 minutes.

Comp to Aux Runtime The maximum amount of time this stage

will run before engaging the next stage. Options are Auto (de-

fault) and 1 to 10° F (0.6 to 5.6° C).

Table of Contents