Advertisement
13
Installation Instructions (Cont.)
Step 4: Drill holes for expansion bolts. The drill diameter is 14mm. Drill 4 holes according to the positioning paper
drawing (hole depth 60mm). Find the hole mark on the positioning paper. Drill 4 holes orderly at the positioning
paper hole mark with a Ø 14 drill bit (use specially-made Ø 14 drill bit to pre-drill for the walls with tiles).
tallation Manual
tallation Manual
nd 7kg models)
Step 5: Fix the hook to wall. Fix the hook with an expansion bolt to the wall.
nd 7kg models)
Take out the expansion bolt from the accessories. Insert the bolt and expansion tubular into the drilled holes.
Insert one nut into the bolt. To prevent the thread being damaged, don't expose the end-thread of the bolt.
Then hammer the 4 bolts into the holes orderly;
After the bolts are hammered into the wall, screw off the nuts and expose the bolts.
Then insert one auxiliary tube to the bolt, and hammer the tube until the expansion tubular is flush with the wall
surface. The expansion tubular is totally expanded then, and the expansion tubular installation is finished.
After finishing the expansion procedure, take out the hook and insert it to the bolt.
Fasten the hook with a socket or a wrench.
When hang upside
When hang upside
down, Fix the holder
down, Fix the holder
at the position of the
at the position of the
two screws.
two screws.
I N A LTO. H O USE
Fix the holder at the
position of the two
screws.
When hang
straight,Hang the
hooks into the
two holes.
When hang
straight,Hang the
hooks into the
two holes.
When hang
upside down,
Hang the hooks
into these two hole
When hang
upside down,
Hang the hooks
into these two hole
Advertisement
