Advertisement
Installation Instructions
Wall Hanging Installation Ma
POWER SOURCE AND GROUNDING
It's recommended to use the dryer on its own dedicated power outlet for both convenience and safety. The power
outlet must be grounded.
Important! If the power cord is damaged, it must be replaced by your local distributor or one of its authorised
service representatives. Please contact your local Customer Care team and ensure the appliance is completely
disconnected from the power supply.
1. Accessories include components:
hooks (2), holders (2), expansion bolts (4), installation
INSTALLATION
positioning paper (1), and installation manual (1).
Refer to the diagram on page 8 of this manual.
Your Dryer should be placed in a ventilated area with a minimum of 80mm between the top of the dryer and
ceiling and with no less than 10cm distance from the wall or cabinetry. It is also recommended that there are no
obstacles within 1.5m of the dryers' front, to ensure ease of operation and ventilation.
Wall Hanging Installation Manual
WALL HANGING INSTALLATION
Step 1: Confirm the following components are all within the included accessories:
Hook
•
2 × Hooks
•
2 × Holders
1. Accessories include components:
•
4 × Expansion bolts
hooks (2), holders (2), expansion bolts (4), installation
•
1 × Installation positioning paper
positioning paper (1), and installation manual (1).
Hook
Holder
Step 2: Determine a location to mount the dryer and confirm that the construction type of the wall and location
is suitable for installation.
•
Do not hang the dryer on the wall if the wall is not solid.
•
The distance in front of the wall must be more than 150cm.
Tip! Ensure power cord and plug is accessible and reaches a power source.
Step 3: Paste the installation positioning paper to the solid wall.
•
Draw a line with a level, and paste the positioning paper based on the line.
Note: Ensure the screw holes will not overlap with the power outlets or taps nearby.
•
The bottom edge of the positioning paper must be 45cm+ higher than the floor.
Remove the adhesive paper behind the positioning paper, and paste the positioning paper
to the wall horizontally.
USE R M A N UA L
(Applicable to 6kg and 7kg models)
Holder
Expansion
Bolt
Expansion
Installation
Bolt
Positioning Paper
(Applicable to 6kg and 7kg models)
Installation
Positioning Paper
When hang upside
down, Fix the holder
at the position of the
two screws.
When hang straight,
Fix the holder at the
position of the two
screws.
12
When hang upside
down, Fix the holder
at the position of the
two screws.
When hang straight,
Fix the holder at the
position of the two
screws.
Advertisement
