Easy@Home EE-3186A User Manual page 13

Ultrasonic Humidifier
A NOTE ABOUT THE WATER LEVEL SENSOR: The water level sensor is made
of three key parts. When cleaning DO NOT MISPLACE these parts and MAKE SURE
that you assemble these three parts correctly after cleaning and before operating
humidifier. The three parts are as follows:
Plastic Cap – this part has 4 flat tabs coming out from the bottom and is
placed on top of a plastic peg
Water Float – a small round part resembling a flat donut located
underneath the Plastic Cap
Peg – plastic peg that secures water float and plastic cap
To clean the water float unscrew the plastic cap from the peg. Remove the water
float and clean with warm sudsy water. Replace the parts by first putting the water
float onto the peg and re-screwing the plastic cap onto peg.
IMPORTANT: Failure to keep this humidifier clean from mineral deposits
normally contained in any water supply will affect the efficiency of the operation.
Customer failure to follow these instructions may void the warranty.
AFTER SALES SUPPORT
888-367-7373
__ CLEANING AND MAINTENANCE
customer-service@wk-usa.com
13