Lindy 382257 User Manual page 5

User Manual
Receiver
Power LED: This LED will illuminate when the receiver is connected to a power source.
Link LED: The LED will flash quickly to indicate pairing has been successful. This LED will flash slowly to
indicate pairing has been unsuccessful.
Reset Button: Short press to copy the EDID of the display to the source device connection. Press and hold
for 3 seconds to restore the transmitter to default settings.
240VAC: Connect to a 100-240VAC power source using the included AC cable.
HDMI Out: Connect to an HDMI display.
IR In: Connect the IR receiver cable to transmit IR control signals from the display side.
IR Pin Diagram
IR Emitter Signal
Power
NC
IR Signal
Power
Grounding
English