Related Manuals for LinMot 0150-3134
Summary of Contents for LinMot 0150-3134
- Page 1 Installation Guide for LinMot USB-CAN Converter for Configuration of E1100 Controller by CAN Bus Art. Nr. 0150-3134 CAN-USB Converter Installation Guide...
- Page 2 NTI Ltd. LinMot® is a registered trademark of NTI Ltd. Note The information in this documentation reflects the stage of development at the time of press and is therefore without obligation.
- Page 3 USB-CAN Converter Installation Guide Introduction........................4 Technical Data ........................5 CAN connector on USB-CAN Converter – Pin assignment ........5 CAN connector on LinMot Controller E1100 ............5 2.2.1 Pinout of the COM Connector: ................5 2.2.2 CAN Pinout of the CMD and ME Connector:........... 5 2.2.3...
- Page 4 USB-CAN Converter Installation Guide 1 Introduction The USB-CAN converter can be used to login from a PC with installed LinMot-Talk 1100 software to one or more E1000 controller by CAN bus. It can help the user to debug and to configure the system in case the serial communication port is occupied (for example if the interface is LinRS).
-
Page 5: Technical Data
(1M/10n to isolated GND) CAN_H N.C. N.C. Table 2-1: Pinning of the CAN connector 2.2 CAN connector on LinMot Controller E1100 2.2.1 Pinout of the COM Connector: DSBU 9 male: Pin 1 RS-485 Tx+ Pin 6 RS-485 Rx- Pin 2 RS-232 TX... -
Page 6: Can Termination
For easy installation, the LinMot CANopen controller has built in termination resistors, which can be activated, if the LinMot controller is at the end of the bus line, and if there is no termination in the connector. -
Page 7: How To Install The Usb-Can Converter
• At least 1.5 MBytes free on hard disk 3.2 Installation Note: Please before connect the USB-CAN converter to the PC install the LinMot-Talk 1100, the driver files are automatically copied on your PC. After the installation of LinMot-Talk 1100 connect the USB-CAN converter to a free USB port. - Page 8 LinMot USB-CAN Converter Installation Guide In the follow window, choose the option “Install the software automatically (Recommended)”. The software will be installed. Installation Guide USB-CAN converter NTI AG / LinMot...