Renfert basic professional Quick Start Manual

Areas of Caution
Never operate a sandblaster without a suitable dust extractor or suitable personal protective clothing as
this can be detrimental to your health. The type of dust extractor must relate to the type of dust produced
by your sandblasting work. It is imperative to adhere to your trade association regulations
(ZH 1/487).
Improper use can risk the danger of damage to eyes and skin. Never blast towards your eyes or onto
unprotected skin.
Before operating, check that the tank lid is correctly fitted. An incorrectly sealed lid can work loose with a
force similar to an explosion. There is thus a risk of harm from flying components and from the sudden
escape of abrasive.
Always disconnect the unit from the compressed air and electricity supplies before carrying out any
maintenance.
Never clean the tank or tank lid with cleaning fluids containing solvents! Solvents may cause a build-up of
micro-cracks in the acrylic therefore creating a risk of explosion.
As long as only the compressed air supply hose is connected, do not operate the foot-switch as the hose
will thrash around and quite possibly cause injury.
Before changing the fluorescent lamp make sure the lamp is unplugged.
Do not push or bend the lamp when exchanging (danger of breaking). If necessary wear gloves or
use a cloth for protection.
Troubleshooting Guide
The basic professional is a high quality product from Renfert. Should the unit not function properly please
refer to the following guide:
basic professional
No. 2941
Fault
No air and
no abrasive.
Air but no /
little sand.
Cause
• Nozzle on
handpiece
blocked.
• The hose
connection
to the foot
switch is
bent.
• Dosage
nozzle
(middle nozzle)
in tank
blocked.
Remedy
• Unsrew the nozzle from the
handpiece and blow through it.
• Activate the foot switch to
clear the jet hose without
nozzle.
• Check the hose and remedy
situation.
• Remove the tank lid.
• Seal the standpipe with isola-
ting tape or Cellotape.
• Replace lid.
• Seal the nozzle on the hand-
piece with finger and activate
foot switch several times.
• Open tank lid and remove the
tape from the standpipe.
Replace lid and commence
sandblasting.
Index