Advertisement
Mounting on a frame
To be able to mount the solar panel to its frame, it needs to be attached to the frame via screws. Use
the pre-drilled holes located on the back side of the unit to attach the frame. Usually, the use of the
four inner pilot holes should be sufficient. However, if you live in a region with strong winds or with
snowfall, the amount of screws should be increased by additionally using the four outer pilot holes.
Ensure that the frame used for mounting is made of a stable, weather and UV light resistant material.
Mounting without frame
Alternatively, the solar module can also be mounted frameless. The solar panels are simply attached
with laminate clamps at the quarter point of the long panel side. Please note that the clamps must not
exceed a size of 12.5 mm, as they are not able to securely attach the unit otherwise. Additionally, it is
important to regard the torque specified by the manufacturer, as the solar panel only has a low toler-
ance regarding punctual loads.
Ground mounting
When mounting the solar panel to the ground, it is important to select an area, in which no parts of the
solar module are covered by trees, buildings or any other objects, as well as choosing an adequate
height, which guarantees that the panel will not be covered by snow.
To be able to position the solar panel safely when mounting it to the ground/flat roof, it is best to place
the stands on a weighted base, e. g. anchoring it to paving slabs. The static of the building needs to be
checked! When the solar module is to be placed on roofs made of corrugated fibre cement, (corrug -
© by WilTec Wildanger Technik GmbH
Item 62391–62394, 61993
Page 6
http://www.WilTec.de
http://www.aoyue.eu
03
2021-1
http://www.teichtip.de
Advertisement
