Installing And Removing The Battery Pack; Operation - DeWalt DCST925 Instruction Manual

English
Attaching the Auxiliary Handle (Fig. A, H)
1. Place the auxiliary handle
base 19 so the upper trimmer pole
2. Hold the auxiliary handle in place and slide the handle
bolts 20 into the handle from the top, threading them
into the handle base.
3. Tighten the handle bolts with the supplied hex
wrench 21 . Ensure the handle is securely attached.
4. Repeat for the other side of the auxiliary handle.
Fig. H
21
20
19
Adjustment (Fig. H, I)

WARNING:
of serious personal injury, turn appliance
off and remove battery before making any
adjustments or removing/installing attachments
or accessories.

WARNING:
Damage or personal injury could result.

WARNING:
APPLIANCE WITHOUT GUARD FIRMLY IN PLACE.
The guard must always be properly attached on the
appliance to protect the user.
The auxiliary handle 3 is positioned to maximize balance.
However, if adjustment is necessary, loosen the four
bolts 20 with a hex wrench
handle 3 up or down the upper trimmer pole
Fig. I

OPERATION


WARNING:
of serious personal injury, turn appliance
off and remove battery before making any
adjustments or removing/installing attachments
or accessories.
8
3 on top of the handle
5 is between them.
3
5
To reduce the risk
Never remove the guard.
NEVER OPERATE
21 and slide the auxiliary
5 .
5
3
20
To reduce the risk

WARNING:
protection that conforms to ANSI Z87.1 (CAN/CSA
Z94.3) while operating this appliance.

WARNING:
making any assembly, adjustments, or changing
accessories. Such preventive safety measures reduce
the risk of starting the TRIMMER accidentally.

CAUTION:
use the appropriate type of cutting line.

CAUTION:
remove any wire, cord, or string-like objects which
could become entangled in the rotating line or spool.
Be particularly careful to avoid any wire which might
be bent outwardly into the path of the appliance, such
as barbs at the base of a chain link fence.

Installing and Removing the Battery Pack

(Fig. J, K)

WARNING:
lever is not engaged to prevent switch actuation
before removing or installing battery.
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack: Align the battery pack
with the rails inside the battery housing
into the housing until the battery pack is firmly seated and
ensure that it does not disengage.
To remove battery pack: Depress the release button
and firmly pull the battery pack out of the battery housing.
Insert it into the charger as described in the charger section
of this manual.
Fig. J
11
10
Fig. K
Proper Hand Position (Fig. L)

WARNING:
personal injury, ALWAYS use proper hand position
as shown.
Always use proper eye
Remove the battery before
Before you begin trimming, only
Inspect area to be trimmed and
Make certain the lock-off
11
10 and slide it
12
12
To reduce the risk of serious