Beachcomber Hot Tubs 160 Owner's Manual page 16

MASSAGE 2
Press the 2 pad once to activate the pump2's low
speed, again for the pump's high speed, and once
more to turn off the pump. The pump's low speed
turns off after 1 hour. The pump's high speed turns
off after 15 minutes of use.
TURBO (OPTIONAL)
Press the pad to cycle through the highest to
lowest setting, then to turn off the turbo. If left
running, the turbo automatically turns off after 15
minutes.
TIME AND TEMPERATURE INVERSION
Press or , then
invert the time and temperature display. Press the
same sequence to set back.
PANEL LOCK
Press the pad, the empty space between "warm"
and "light" pads, then the
When locked, the display will show the temperature
you have chosen along with the "lock" symbol. To
unlock, press the pad, then the space between
"warm" and "light" pads, then the
2 seconds.
The lock symbol will disappear and all panel pads
will work again.
For hot tubs with turbo option:
Press , , within 3 seconds.
To unlock, press the
2 seconds.
TEMPERATURE/FILTER CYCLE LOCK
Press , then press the
between "warm" and "light" pads, then the
within 3 seconds. The
now locked. The display will show the "lock" symbol
and "set heat". It will also display the temperature
you've chosen when the
unlock, press the pad, the empty space between
"warm and "light" pads, then the
seconds. The lock symbol will disappear and all
panel pads will work again.
1 within 3 seconds to
pad within 3 seconds.
pad within
, , pads within
, the empty space
, , and buttons are
or is pressed. To
pad within 2
For hot tubs with turbo option:
Press
seconds to lock. To unlock, press the
pads within 2 seconds.
STANDBY MODE
Press
prevent the hot tub from operating at any time.
Standby mode should be used when replacing the
filter. All hot tub functions will be disabled except
for freeze control. Press any button to resume hot
tub operation.
DISPLAY MESSAGES
"OH"
"Overheat" - The hot tub has shut down. Either the
water has reached 112°F / 44°C, or the high limit
sensor has detected 118°F / 48°C at the heater.
DO NOT ENTER THE WATER! Remove the hot tub
cover and allow water to cool. At 110°F / 43°C, the
hot tub should automatically reset. If the hot tub
does not reset, then turn off all power to the hot tub
and contact your dealer or service organization.
"FLO"
"Flow" (Flashing) – Flow of water is inhibited. Check
and open flow valves. Check for correct water level.
Clean or replace your Microfilter.
"FLO"
"Flow" (Not flashing) - A pressure switch has
malfunctioned. Contact your dealer or service
organization.
"COOL"
pad
"Cool" – Water temperature is more than 20°F / 7°C
below the temperature you last set. No action
required. Hot tub is functioning properly.
"ICE"
"Ice" – Potential freeze condition is detected. No
action required. Pump(s) will automatically activate
regardless of hot tub's status.
- 14 -
, , , then the
or then within 3 seconds, to
pad within 3
, ,