Beachcomber Hot Tubs 160 Owner's Manual

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

Beachcomber Hot Tubs

Owner's Manual

Table of Contents

Summary of Contents for Beachcomber Hot Tubs 160

Page 1 Beachcomber Hot Tubs Owner’s Manual...
Page 2: Table Of Contents
Digital Systems Programming and operation ......9 • 300 Series Digital 1000 System (160 included) ....9 •...
Page 3: Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS To reduce the risk of drowning from hair and body entrapment, install suction fitting(s) with a marked flow rate that is not less than the flow rate marked IMPORTANT! READ AND FOLLOW on the remote packaged unit.(note: these are factory ALL INSTRUCTIONS.
Page 4: Beachcomber Safety Features
Once the Protec equipment is hooked up, using the Molded Interior Steps separate instructions provided in the Protec Beachcomber hot tubs are made with checker plate Equipment box and the electrical connection is flooring designed to make entry and exit safer.
Page 5: Water Care Product Startup Procedure
3. Fill the hot tub to half way up the skimmer open- how many times a day the filter hours occur. ing. Note: If your hot tub is Hush Pump equipped On 700 series, you can adjust temperature, amount your level can be lowered to one third up the of hours the hot tub filters and a time clock that skimmer opening.
Page 6: Equipment Configuration Diagrams
EQUIPMENT CONFIGURATION DIAGRAMS - 4 -...
Page 7 EQUIPMENT CONFIGURATION DIAGRAMS - 5 -...
Page 8 EQUIPMENT CONFIGURATION DIAGRAMS - 6 -...
Page 9 EQUIPMENT CONFIGURATION DIAGRAMS - 7 -...
Page 10 EQUIPMENT CONFIGURATION DIAGRAMS - 8 -...
Page 11: Digital Systems Programming And Operation
DIGITAL SYSTEMS, PROGRAMMING, OPERATION AND ERROR MESSAGES 300 Series Digital 1000 System including Model 160 START UP PRESET FILTER CYCLES When your hot tub is first powered up, it will Your hot tub is set to filter itself twice a day. The first automatically heat and maintain 100°F / 37.5°C...
Page 12 "FL" "Flow" (Flashing) – Flow of water is inhibited. Check and open any closed knife valves. Check for correct water level. Clean or replace your Microfilter. "FL" "Flow" (Not flashing) - Flow switch has malfunc- tioned. Contact your dealer or service organization. "Sn"...
Page 13: 500 Series Digital 2000 System
DIGITAL SYSTEMS, PROGRAMMING, OPERATION AND ERROR MESSAGES 500 Series Digital 2000 System START UP TURBO (OPTIONAL) When your hot tub is first powered up, it will Press the pad to turn the blower on and off. If automatically heat and maintain 100°F / 37.5°C left running, the turbo automatically turns off after until you change the set temperature.
Page 14 During filtration the optional ozone generator (if "Sb" installed) will run. If Turbo equipped, the turbo will Standby" - Hot tub is in standby mode. All hot tub come on for 30 seconds at the start of the first functions are disabled except for freeze control. filter cycle.
Page 15: 700 Series Digital 3000 System
DIGITAL SYSTEMS, PROGRAMMING, OPERATION AND ERROR MESSAGES 700 Series Digital 3000 System to disable the heater. Press , to see "SET STOP START UP FILTER 1" and adjust the time with When your hot tub is first powered up, it begins done above.
Page 16 For hot tubs with turbo option: MASSAGE 2 Press , then the pad within 3 Press the 2 pad once to activate the pump2’s low seconds to lock. To unlock, press the speed, again for the pump’s high speed, and once pads within 2 seconds.
Page 17 "Sn1" "Sensor1" - Hot tub is shut down. The high-limit sensor is not working. Contact your dealer or service organization. "Sn3" "Sensor3" - Hot tub is shut down. The water temperature sensor is not working. Contact your dealer or service organization. "Stby"...
Page 18: Model 320M And 320 Xm Mechanical Systems
High–Limit Reset MODEL 320M AND 320 XM This is a safety device that will shut the system MECHANICAL SYSTEMS down if a water temperature above 110ºF is sensed These are non digital systems which use a at the heater housing. A return knife valve on the mechanical equipment pak.
Page 19: Water Care And Maintenance
refilling. Use test strips to check or have your WATER CARE AND MAINTENANCE dealer perform the test. The ideal range is Now that you are familiar with the operation of your 100-120 ppm. Beachcomber hot tub you need to become familiar with the care and maintenance of it.
Page 20: Beachcomber Hot Tub Care And Maintenance
Heatshield and Step Tops HOT TUB CARE AND MAINTENANCE As with any vinyl product that is exposed to the Filter Removal and Maintenance weather, the better the care, the longer it will last. Use a mild dish soap solution to remove dirt on the The 25 sq ft.
Page 21: Operation Of Beachcomber Hot Tub Interior Features
Hot Tub Light foot jets and the remainder of the seat jets on the All Beachcomber hot tubs come with a standard 11 left side of the hot tub. On 700 series hot tubs with watt, 12 volt incandescent under water light. On 700...
Page 22 To replace a burned out bulb, turn off the power, Ozone Generator (optional feature) drain the hot tub, and unscrew the lens with the Installation of an ozone generator will reduce the wrench provided with your hot tub. Carefully pull out demand on your primary sanitizer which in turn will the burned out bulb and then replace with a new reduce the frequency of sanitizer addition.
Page 23: Draining A Beachcomber Hot Tub
4. Lock your cover on the hot tub to maintain a safe DRAINING A BEACHCOMBER HOT TUB environment for pets or children. If in a high wind Before draining, check the sanitizer level; it should area install Hurricane straps available from your not be above 1.0 to ensure no harm is done to the local Beachcomber dealer.
Page 24: Shut Down Procedures
one pump to the front of the other pumps. There is Removing these allows the last bit of water in the also a 1 minute, low speed purge cycle that happens bottom half of the pump to drain out. at the start of each filter cycle. Note: If refilling your 4.
Page 25: Water Quality Troubleshooting Guide
HOT TUB OPERATION TROUBLESHOOTING GUIDE Problem Symptom Most Likely Cause Solution Control panel display is Filter is dirty Put hot tub on Standby, remove alternating between FL or FLO filter and clean or replace. and the water temperature. Knife valve is closed. Ensure all knife valves are in the The pump is running.
Page 26 Pump is surging on high speed. RFM jet nozzles are pointed toward Redirect nozzles away from large large suction fitting in foot well. suction fitting. Hush pump is not running 24 Filter cycles have been altered at On 500 series turn power off then hours a day.
Page 27 Remote control does not work Remote control batteries are low, Change batteries or contact when pointing directly at CD player. or remote is defective. your local dealer. The water is cloudy. Sanitizer level is to low. Shock-treat the water and then maintain a sanitizer level of 3 –...
Page 28: Beachcomber Hot Tub Care And Maintenance Record
BEACHCOMBER HOT TUB CARE AND MAINTENANCE RECORD Date Hose off Soak filter Drain and Clean and Re stain filter element element in refill tub treat tub cedar cleaning solution cover cabinet - 26 -...
Page 29: Beachcomber Hot Tub Model # Details Chart
4123 lbs. Digital 3000 3.5 x 4.5 hp 1507 litres 363 kg 1870 kg Notes: 320 and 320M can be ordered upgraded to 220/240 volt. 320X, 320XM, 520 and 160 can be ordered downgraded to 110/120 volt. - 27 -...
Page 30 Contact us: Beachcomber Home Office 13245 Comber Way, Surrey, B.C. Canada V3W 5V8 North American Customer Care 1.800.663.6557 San Diego Beachcomber Worldwide Centre 1.866.250.7878 Fax line: 760.560.7882 Arnhem Beachcomber European Centre 31 (0) 26 327 4822 Fax line: 31 (0) 26 323 7836 Toronto Beachcomber Development Centre: 1.800.268.3966 Fax line: 905.829.2848...

This manual is also suitable for:

320 320m 320x 320xm 350 520 ... Show all