Maintenance - Husqvarna R 214C Operator's Manual

4. To release the parking brake, press the parking
brake pedal again.
To get a good cutting result
• For best performance, do maintenance on the
product regularly as given in the maintenance
Maintenance schedule on page
schedule. Refer to
15 .
• Do not cut a wet lawn. Wet grass can give a bad
cutting result.
Introduction
WARNING:
maintenance work you must read and
understand the safety chapter.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.

Maintenance

Make sure that nuts and screws are tightened
Make sure that there are no fuel or oil leaks
To clean the product on page 16
Clean as given in
Clean the inner surface of the cutting deck, around the blades
Clean around the muffler
Make sure that the cold air intake of the engine is not blocked
Make sure that the safety devices are not defective
Examine and do a test of the brakes
Do a check of the engine oil level
Do a check of the oil level in the transmission
Do a check of the steering wires
Examine the blades in the cutting deck
Clean the cutting deck, below the belt covers and below the cutting
deck
Make sure that the tire pressure is correct
Do a check of the parking brake
Replace the engine oil
Replace the oil filter
1590 - 001 - 11.12.2020
Maintenance
Before you do any
• Start with a high cutting height and decrease it
gradually.
• Cut with blades that rotate at high speed (highest
permitted engine speed, refer to
page 28 ). Move the product forward at low speed. If
the grass is not too high and thick, you can get a
good cutting result also at a higher speed.
• Cut the grass in an irregular pattern.
• To get the best cutting result, cut the grass
frequently and use the Bioclip
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
Note:
If more than one time interval is identified in the
table, the shortest time interval is for the first
maintenance only.
Daily maintenance be-
fore operation
Technical data on
®
function.
Maintenance in-
terval in hours
25 50
*
*
X
X
X
X
X
*
X
X
X
X
X X
X X
X
X
X
100
X
X
15