Installing The Vxswitch-32 - EMS VisionSwitch-32 VXSwitch32-SA User Manual

Installing the VXSwitch-32

Note:
You are likely to need a flat blade and a Phillips head
screwdriver for the installation so please ensure you have
these to hand before you begin.
• Power down your complete system (including peripherals)
• Disconnect all the cables connected to the PC, noting the
• Locate an available PCI slot to install your VXSwitch-32.
Note:
The VXSwitch32-SA requires one PCI slot, and two expan-
sion slots
• Holding the card firmly by its top edge at each end of the
• Using the retaining screw, secure the bracket(s) to the back
• Replace the cover on your PC.
VXSwitch-32
at the PC and the main power supply.
positions for correct reconnection after the VXSwitch-32 is
installed. Carefully remove the cover from your PC.
You may need to remove the expansion slot cover and
screw, please retain these for future use.
card's length, slide it into the slot.
panel.
Installing the VXSwitch-32
4