Installing Vxswitch32-V With Vigilant Cards - EMS VisionSwitch-32 VXSwitch32-SA User Manual

Installing VXSwitch32-V with Vigilant Cards

The VXSwitch32-V is connected to the Vigilant card via inter-
card ribbon cables, (VSRC-set) enabling the Vigilant video
overlays to select 1 of 32 possible video sources. The
VXSwitch32-V supports up to eight Vigilant-Plus cards
Install and configure all Vigilant-Plus cards in the system, care-
fully following the iH installation instructions. Ensure that your
multi-screen system is working correctly before installing the
VXSwitch32-X.
Once the VXSwitch32-V is installed it can be connected to the
Vigilant cards.
You will need to determine the ordering of the Vigilant cards to
enable the correct connection. The example below displays
eight Vigilant cards configured as a 4 x 8 monitor video wall.
The ordering in this example is the first Vigilant (the Master Vig-
ilant card) always drives the first 4 screens, in this case the top
four from the left (numbered 1). The second Vigilant drives the
next four (numbered 2), and so on. Count the screens starting
from the top left of the video wall and then across from left to
right:
Once the order of the Vigilant cards has be determined connect
the ribbon cables as follows:
VXSwitch-32 Installing VXSwitch32-V with Vigi-
12