Download Print this page

Wire Diagram; Before Installing This Product; Technical Support - Boss Audio Systems Rebel Power Sports MRGB65B User Manual

Marine grade 6.5″ coax speakers featuring 20 color rgb led's and rf remote controller

Advertisement

WIRE DIAGRAM

REMOTE OUT
GROUND CABLE
+12V BLUE
YOUR RADIO
Normally Open
ON/OFF ACC switch
+12V RED
NO
C
Normally open
ACC switch
(not included)
OPTIONAL DIRECT BATTERY WIRING CIRCUIT
CHASSIS
GROUND
POINT
FUSE / FUSE HOLDER
(NOT INCLUDED)
- Do not touch the speaker flex wire
- Secure all wiring with wire ties
- Properly seal connections to ensure water tight connections
CAUTION!! Do not ground or short the RGB wires
3
MRGB65B-UM-DRAFT.indd 3-4
YOUR AMPLIFIER
BLACK
CHASSIS
GROUND
POINT
METAL FRAME
+12V BATTERY YELLOW
+12VDC
YOUR
OPTIONAL
BATTERY
BATTERY
FUSE AND FUSE HOLDER
KILL SWITCH
(NOT INCLUDED)
3A
Recommended 16 ~ 18ga Primary Extension Wire
(not included)
OPTIONAL

BEFORE INSTALLING THIS PRODUCT

SPEAKER 1
SPEAKER 2
RGB POWER
INPUT
To avoid short-circuiting, cover any disconnected leads with insulating
tape. It is especially important to insulate any unused wires, which if left
uncovered may cause a short circuit. When connecting other devices to this
product, refer to the manual for the product to be connected. The black cable
is ground, make sure to connect the ground wire first.
Ensure that the ground cable is properly connected to metal parts of the
vehicles body frame or direct to the battery if your vehicle does not have a
grounded chassis frame The ground cable of this units power amp and a
second powered system must be connected to the frame separately with
different screws. If the screw for the ground wire loosens or falls out, it
could result in fire or malfunction.
www.bossaudio.com/technical-support
TOOLS NEEDED:
- Wrench and/or Pliers
- #2 Phillips screwdriver
- Crimp tool
- Handsaw / Jig Saw
- Electrical tape
To avoid potential shorts in the
electrical system, be sure to
disconnect the (–) battery cable before
installation. Use this unit with a 12-volt
battery and negative grounding only.
Failure to do so may result in a fire or
malfunction.
When replacing the fuse, be sure to only use a fuse
of the rating specified on this product.

TECHNICAL SUPPORT

1-805-751-4853
4
2/23/2016 3:51:29 PM

Advertisement

loading