BGH BT2909S Service Manual page 18

HPARALLEL
AUTO OFFSET
*Notes:
1. For NTSC signal, the "-50" will replace with "-60".
2. For NTSC signal, only the "HCEN-60" and "HSIZE-60" items need the adjustment,
the other items use the same data as PAL signal.
3. On producing, please use the "AUTO OFFSET" (On page "2") function to easy the
geometry adjustment of NTSC signal. When finished the PAL signal geometry adjustment,
press "2" key to enter page "2" to select "AUTO OFFSET" item, press "y" key to active the
automatic offset function. Then the geometry adjustment of NTSC signal will finish
automated. If now the geometry of NTSC signal is look good, it not needed to adjust the
geometry of NTSC signal any more.
3.6 Producing parameter setup and option
1. Enter P-Mode, press key "4" to select page "4".Set the corresponding item to require
value. See below table 3.6.1 for detailed description.
Table 3.6.1: Producing parameter setup and option page "4"
OSD menu
WARM UP STATUS
SHOP INIT
DCXO
FACTORY HOTKEY
POWER ON MODE
EEPROM INIT
2. Enter P-Mode, press key "5" to select page "5". Set the corresponding item to require
value. See below table 3.6.2 for detailed description.
Table 3.6.2: Producing parameter setup and option page "5"
OSD menu Default Value
Track. Mode
VX Normal
Chassis Name
Issued on
Updated on
32 Horizontal parallelogram(HP)
0 Automatic offset NTSC geometry
Default Value
0 Set aging mode
0 Set the shopping status
Crystal oscillator
2
frequency adjustment
1 Set factory hotkey
LAST Set the power on mode
0 EEPROM initial
Description
1 EHT tracking mode
25 4:3 mode vertical zoom
NX56-LA
2008-05-19
Description
0=EHT tracking only on vertical
1=EHT tracking on vertical and EW
Serial No.
Page
Version
Adjust to right value
See below description
Remark
0=Aging mode off
1=Aging mode on
0=>1= Set the shopping status
Adjust this value to get the max
color synchronization range
0="FACTORY HOTKEY" off
1="FACTORY HOTKEY" on
ON=On when power on
STB=Standby when power on
LAST=Last power off status
0=>1=Active EEPROM initial
Remark
Don't adjust, use default
Page 10 of 12
1.0