Table of Contents
Advertisement
10 Installation
10.1. Before Installation
WARNING
Engage dealer or specialist for installation. If installation done by the user is defective, it will cause water leakage, electrical
shock or fire.
Use the specified cable (2.5mm ) and connect tightly for indoor/outdoor connection.
Power supply connection to a circuit breaker for the permanent connection. Use an approved 25A circuit breaker for the
permanent connection. lt must be a 4-pole switch with a minimum 3 mm contact gap.
The unit must be earthed, or it will cause fire or electric shock.
Accessory parts attached together with the Indoor Unit.
No.
Accessories parts
1
Fixing Tool of Indoor Unit
2
Remote Control
3
Fixing Screw
4
Battery
Band
5
SELECT THE BEST LOCATION
INDOOR UNIT
There should not be any heat source or steam near the unit.
●
There should not be any obstacles blocking the air circulation.
●
●
A place where air circulation in the room is good.
A place where drainage can be easily done.
●
A place where noise prevention is taken into consideration.
●
Do not install the unit near the door way.
●
Ensure the spaces indicated by arrows from the wall, ceiling, fence or other obstacles.
●
OUTDOOR UNIT
If an awning is built over the unit to prevent direct sunlight or rain, be careful that heat radiation from the condenser is
●
not obstructed.
There should not be any animal or plant which could be affected by hot air discharged.
●
●
Keep the spaces indicated by arrows from wall, ceiling, fence or other obstacles.
●
Do not place any obstacles which may cause a short circuit of the discharged air.
2
Qty.
No.
6
1
1
7
8
4
2
9
3
10
21
Accessories parts
Bushing for Piping
Bushing for Cable
Heat Insulator
Operating Instructions
Installation Instructions
CS-C45FFH / CU-C45FFH
Qty.
1
1
1
1
1
Hide quick links:
Advertisement
Table of Contents
