Safety Instructions; Specified Conditions Of Use; Maintenance Instruction - Chicago Pneumatic CP12CHE Series Operator's Manual

EN
ENGLISH
(ENGLISH)
1. Technical Data
Voltage range (output)
voltage input
Mains Connection
Quick charge current
Maintaining charge
Battery charging time Li-Ion 4.0 Ah
Weight
WARNING! Read all safety warnings and all instructions, including those given in the accompanying brochure. Failure to
follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions
for future reference.

2. Safety Instructions

Do not dispose of used battery packs in the household refuse or by burning them. CP Distributors offer to retrieve old batteries to protect our environment. Do
not store the battery pack together with metal objects (short circuit risk).
Use only System CP chargers for charging System CP battery packs. Do not use battery packs from other systems. The following battery packs can be charged
with this charger:
voltage Battery
12 V CP12XP
Do not try to charge non-rechargeable batteries with this charger. No metal parts must be allowed to enter the battery section of the charger (short circuit risk).
Never break open battery packs and chargers and store only in dry rooms. Keep dry at all times. Do not touch the tool with conducting objects. Never charge a
damaged battery pack. Replace by a new one. Before use check machine, cable, and plug for any damages or material fatigue. Repairs should only be carried
out by authorised Service Agents.
This appliance is not intended to be used or cleaned by persons with reduced physical, sen-
sory or mental capabilities, or lack of experience or knowledge, unless they have been given
instructions concerning the safe use of the appliance by a person legally responsible for
their safety. They should be supervised whilst using the appliance. Children shall not use,
clean or play with this appliance, which when not in use should be secured out of their reach.

3. Specified Conditions of Use

The quick charger can charge CP 20V batteries pack. Do not use this product in any other way as stated for normal use.
4. Mains Connection
Connect only to single-phase a.c. current and only to the system voltage indicated on the rating plate. It is also possible to connect to sockets without an earthing
contact as the design conforms to safety class II.
5. Battery
Avoid extended exposure to heat or sunshine (risk of overheating). The contacts of chargers and battery packs must be kept clean.
6. characteristic
After inserting the battery into the reception of the charger the battery will automatically be charged (red LED stays lit, green LED flashes). When a hot or cold
battery pack is inserted into the charger(flashing red lamp), charging will begin automatically once the battery reaches the correct charging temperature (Li-Ion 0°C-
50°C). Charging time varies depending on the battery temperature,charge needed and the type of battery pack being charged. As soon as charging is completed,
the charger switches over to "trickle" charge to maintain the full capacity (green control lamp is illuminated continuously) It is not necessary to remove the battery
after charging. The battery can be stored permanently in the charger without the danger of being overcharged. If both LEDs fl ash at the same time, either the bat-
tery has not been completely mounted or there is a fault in the battery or the charger. For safety reasons you must stop using the charger and battery immediately
and have them inspected by an CP Customer Service Centre.

7. Maintenance instruction

• Follow local country environmental regulations for safe handling and disposal of all components.
• Maintenance and repair work must be carried out by qualified personnel using only original spare parts. Contact the manufacturer or your nearest authorised
dealer for advice on technical service or if you require spare parts.
• Always ensure that the machine is disconnected from energy source to avoid accidental operation.
• High wear parts are underlined in the parts list.
• To keep downtime to a minimum, the following service kits are recommended :
Tune-up kit: see part list
CP12CHE,CP12CHU,CP12CHK ,CP12CHA, CP12CHKC Series
DC12 V
220-240V 50/60Hz for Europe and ANZ;120V 60Hz for US, 220V 60Hz for Korea
Plug type A for US;type C for EU and Korea; type I for Australia;
3.0 A
500 mA
30 min
0.46 kg
Cell type
Li-Ion
80%
90%
capacity No. of Battery Cells
<=1.5 Ah 3
12 V Battery Charger