Panasonic WV-S1531LTN Important Information Manual page 21

■ Indicators and buttons
S1531
INITIAL SET button (Initializing / NTSC ⇔ PAL switch button)
A
F SD memory card warning/
error indicator
INITIAL SET button (Initializing / NTSC ⇔ PAL switch button)
A
Follow the steps below to initialize the network camera.
⑴
Turn off the power of the camera. When using a PoE hub, disconnect the Ethernet cable from
the camera. When using an external power supply, disconnect the 2P power cable (accessory)
from the 12 V DC power supply terminal.
⑵
Turn on the power of the camera while pressing the INITIAL SET button, and make sure to
release the button after approximately 15 seconds. In about 2 minutes later, the camera will
start up and the settings including the network settings will be initialized. Retry if the camera
does not start up normally.
IMPORTANT:
⿟ When the camera is initialized, the settings including the network settings will be initialized.
Before initializing the settings, it is recommended to write down the settings in advance.
⿟ Do not turn off the power of the camera during the process of initialization. Otherwise, it may
fail to initialize and may cause malfunction.
⿟
When the INITIAL SET button is pressed (less than 1 second) to switch the output signal of the
MONITOR OUT terminal, the MONITOR OUT terminal can be switched for the NTSC monitor/
PAL monitor.
G SD ON/OFF button
SD memory card slot (SD)
B LINK indicator
C ACT indicator
E SD ERROR/AF indicator
D SD MOUNT indicator
I TELE button
J WIDE button
H AF button
21
S1511