Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
Refer to
Wear eye
instructions
protection
1. SAFETY
WARNING! Disconnect the spray gun from the air supply before changing accessories, servicing or performing any maintenance.
9
Familiarise yourself with this products application and limitations, as well as the specific potential hazards peculiar to the spray gun.
Paint cup remains pressurised after gun is disconnected from air line.
DO NOT pull the trigger, but release the pressure by gently opening cup.
9
9
Maintain the spray gun in good condition (use an authorised service agent). Replace or repair damaged parts.
9
Use recommended parts only. Non authorised parts may be dangerous and will invalidate the warranty.
9
Locate the spray gun in an adequate working area for its function, keep area clean and tidy and free from unrelated materials, and
ensure there is adequate ventilation and lighting.
9
Keep the spray gun clean for best and safest performance.
9
Ensure the air system is suitable to the spray gun air consumption, (see specifications).
9
Remove ill fitting clothing. Remove ties, watches, rings, and other loose jewellery, and tie back long hair.
9
Keep children and unauthorised persons away from the working area.
DO NOT point spray gun at yourself, at other persons or animals.
8
DO NOT carry the by the air hose, or pull the hose from the air supply.
8
DO NOT use the spray gun for any purpose other than for which it is designed.
8
DO NOT allow untrained persons to operate the spray gun.
8
DO NOT get the spray gun wet or use in damp or wet locations or areas where there is condensation.
8
DO NOT operate gun if any parts are missing or damaged as this may cause failure or personal injury.
8
DO NOT direct air from the air hose at yourself or others.
8
9
Avoid unintentional operation. When not in use switch the spray gun off, and disconnect from the air supply.
2. INTRODUCTION
Gravity feed spray gun designed for applying base coats. Features air and paint flow controls for fine adjustment of spray pattern. HVLP
Technology and precision engineering delivers consistent and unrivalled results. Suitable for water based paints.
3. SPECIFICATION
Model No ...................................................................HVLP01
Standard Set-Up ......................................................... 1.4mm
Available Set-Up ................................................... 1.3/1.7mm
Recommended Air Pressure .................................... 30-43psi
Air Consumption........................................................ 14.5cfm
Pot Capacity.................................................................. 600m
4. CONTENTS
ITEM
DESCRIPTION
1
Gun
1.4 Gun Head (MAX 10psi)
2
3
Pot (600ml)
4
Strainer
5
Universal Spanner
6
Brush (A)
7
Brush (B)
© Jack Sealey Limited
INSTRUCTIONS FOR
HVLP GRAVITY FEED SPRAY GUN 1.4mm SET-UP
HVLP01
MODEL NO:
Wear protective
Wear safety
gloves
footwear
Qty
1
1
1
1
1
1
1
Wear a mask
Wear protective
clothing
fig.2
HVLP01 | Issue 2 (H,F)30/01/18