Table of Contents
Advertisement
1. Carriage bolt (3/8 x 2-1/2
inches)
2. Nut
4
Installing the Broom to the
Machine
No Parts Required
Procedure
1.
Place the broom on a level floor with the kick
stands in the down position; refer to
Kickstands (page
2.
Remove the stop assembly from the broom lock
bracket
(Figure
6).
1. Stop assembly
3.
Ensure that the hydraulic hoses are out of the
way from the broom quick-attach triangle.
Figure 5
3. Broom lock bracket
Using the
10).
Figure 6
4.
Engage the quick pin on the machine
quick-attach assembly
Note:
The pin will protrude from the quick-attach
triangle.
g210328
5.
Slowly move the machine up to the broom so
that the quick-attach triangle of the machine
enters the broom quick-attach triangle and
presses the engagement pin
6.
If necessary, adjust the coupler channel as
follows:
A.
Loosen the fasteners on the channel, slide
the channel up or down, and tighten the
fasteners
g214226
6
(Figure
7).
Figure 7
(Figure
Figure 8
(Figure
9).
g196445
8).
g196446
Advertisement
Table of Contents
