Hitachi PC-ARH Installation And Operation Manual page 7

Installation in case of Night Table:

A. Cut an installation hole to expose the remote controller as
shown in the fi gure
B. Prepare bolts.

NOTE
Determine the bolt layout depending on the spacers (fi eld
supplied).
C. Place the bolts on the holding bracket and fi x the spacers
with the nuts.
- Bolt (Field Supplied)
- Nut (Field Supplied)
- Spacer (Field Supplied)

NOTE
Allow a distance of more than 30 mm between spacer
holes.
D. Remove the front decorative cover and attach the remote
control switch into the installation hole.
4. Attach the controller to the holding bracket and connect the cable
as is showed in the fi gure.
5. Attach the Remote control onto the holding bracket.
Firstly, attach the upper side, and then the lower side.
Installation Work
Bolt
or more
Spacer
Nut (Field supplied)
Insert the connector
9
Bolt (Field supplied)
Nut (Field supplied)
Spacer (Field supplied)
Lead the cable through
the groove