Amperes iPX5151 Instruction Manual
  1. Manuals
  2. Brands
  3. Amperes Manuals
  4. Receiver
  5. iPX5151
  6. Instruction manual

Amperes iPX5151 Instruction Manual

Ethernet paging client
Hide thumbs Also See for iPX5151:
Table of Contents

Advertisement

Quick Links

Download this manual
INSTRUCTION MANUAL
iPX5151
Ethernet Paging Client
ULTRA LOW LATENCY
Thank you for choosing another quality product from Amperes Electronics.
iPX5151 is an Ethernet Paging Client which receives and transmits paging audio and RS485 data from digital paging microphone,
which is then fed to a receiving paging client via Ethernet connection. The receiving client can then broadcast the audio via PA mixer
for amplification.
iPX5151 is now refreshed with newer technology for Ultra Low Latency audio transmission, thus reducing the delay in sound delivery.
Parameter settings are done using web browser, connected directly to the unit for channel setup, bass and treble controls, volume, etc.
Applicable for Version 2.17 and above
VER 4 / 2021

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the iPX5151 and is the answer not in the manual?

Questions and answers

Related Manuals for Amperes iPX5151

Summary of Contents for Amperes iPX5151

  • Page 1 Ultra Low Latency audio transmission, thus reducing the delay in sound delivery. Parameter settings are done using web browser, connected directly to the unit for channel setup, bass and treble controls, volume, etc.

  • Page 2: Parts Identification

    6. REMOTE TRIGGER PORT We can activate iPX5151 paging using voltage free dry contact. Link PM series paging mic / MR1301 message recorder / TI6100 Telephone Interface dry contact to this port will allow these audio sources activate iPX5151 and have their analog audio accepted by iPX5151.
  • Page 3 Paging Audio & Data (Output Mode) SUB RACK Note: In a system, only one iPX5101 is required, no matter what the size of the system or the number of clients ( iPX5151 / iPX5155) are installed. iPX5151 | ETHERNET PAGING CLIENT PAGE 3...

  • Page 4: Device Info

    Device Setup Via Browser iPX5151 shall require some setups via web browser. Kindly follow instruction listed below. Open a browser (Chrome / IE) and enter iPX5151 IP address. The default address is 192.168.0.100. Default username and password are both “admin”.

  • Page 5: Paging Configuration

    Room A Paging Client System Unit Configuration: We can enter a meaningful Device Name here, e.g. “Room A Paging Client”. The name will be shown in Device Info page of iPX5151 and iPX5101 Paging Server - Client Browser tab. Enter new username...

  • Page 6: Update Firmware

    Update firmware in Bootloader Mode If the iPX5151 “hanged”, it is required to perform system reset by : 1. Press & hold the reset button until “ STREAMING ” LED is turned ON. This will set the IP address to default address 192.168.0.100.

  • Page 7: Technical Specification

    Case : Dimension (WxHxD) 100 x 147 x 40 mm Weight 300 g Note: The above specifications are correct at time of printing but subjected to changes without prior notice due to product improvements. iPX5151 | ETHERNET PAGING CLIENT PAGE 7...

  • Page 8: Warranty Conditions

    Only Amperes Electronics Service Centres are allowed to make warranty repairs : a list of Amperes Electronics Service Centres may be asked for by the purchaser or send directly to Amperes Electronics Sdn Bhd at 70 Jalan Industri PBP 3, Tmn Perindustrian Pusat Bandar Puchong, 47100, Puchong, Selangor, Malaysia or its authorized dealers.

Table of Contents