Operating The Walkie-Talkies; Switching The Walkie-Talkies On/Off; Volume Control; Transmitting And Receiving - Grundig GWT 2000 User Manual

OPERATING THE WALKIE-TALKIES
Display and notation of operating sequences
Press the button depicted
,
Press and hold the button displayed
Release the button displayed
,
Display indicator
Speak into the microphone

Switching the walkie-talkies on/off

The main switch is located on the underside of each walkie talkie. Set
the switch to ON before switching the walkie-talkie on.
A beep tone is heard. The channel and code used last time will
display and the Ready LED flashes.
If the walkie-talkie is to remain unused for a longer period, we recom-
mend you set the main switch to OFF. If set the switch to OFF for a
long time, the channel and code will return to its default setting.

Volume control

/

Transmitting and receiving

Transmitting
After pressing the
button is pressed longer than 60 seconds, a warning signal is issued.
,
Note:
Hold the walkie-talkie approx. 5 to 7 cm from your mouth and
speak at a normal volume. In order to talk to other subscribers,
the respective walkie-talkies must be set to the same channel and
CTCSS/CDCSS codes.
Receiving
,
Note:
Radio signals cannot be received when the button is being pressed.
Switch the walkie-talkie on
Switch the walkie-talkie off
Raise or lower the volume (16 levels)
button, the Transmit LED lights up. If the
,
Transmission is interrupted.
Receive
5