Asus TUF B360M-PLUS GAMING/BR Manual page 12

Hide thumbs Also See for TUF B360M-PLUS GAMING/BR:
Table of Contents

Advertisement

Intel
B360 Serial ATA 6.0Gb/s connectors (7-pin SATA6G_1~6)
®
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA
6.0 Gb/s signal cables.
RGB header (4-pin RGB_HEADER)
This header is for RGB LED strips.
The RGB header supports 5050 RGB multi-color LED strips (12V/G/R/B), with a
maximum power rating of 3A (12V), and no longer than 3 m.
Before you install or remove any component, ensure that the ATX power supply is
switched off or the power cord is detached from the power supply. Failure to do so may
cause severe damage to the motherboard, peripherals, or components.
Actual lighting and color will vary with LED strip.
If your LED strip does not light up, check if the RGB LED extension cable and the
RGB LED strip is connected in the correct orientation, and the 12V connector is
aligned with the 12V header on the motherboard.
The LED strip will only light up when the system is operating.
The LED strips are purchased separately.
Clear RTC RAM (2-pin CLRTC)
This header allows you to clear the CMOS RTC RAM data of the system setup
information such as date, time, and system passwords.
To erase the RTC RAM:
1.
Turn OFF the computer and unplug the power cord.
2.
Use a metal object such as a screwdriver to short the two pins.
3.
Plug the power cord and turn ON the computer.
4.
Hold down the <Del> key during the boot process and enter BIOS setup to
re-enter data.
If the steps above do not help, remove the onboard battery and short the two pins again
to clear the CMOS RTC RAM data. After clearing the CMOS, reinstall the battery.
System panel connector (20-5 pin PANEL)
This connector supports several chassis-mounted functions.
USB 2.0 connectors (10-1 pin USB1011, USB914)
Connect a USB module cable to any of these connectors, then install the module
to a slot opening at the back of the system chassis. These USB connectors comply
with USB 2.0 specifications and supports up to 480Mbps connection speed.
Serial port connector (10-1 pin COM)
Connect the serial port module cable to this connector, then install the module to a
slot opening at the back of the system chassis.
1-3
PIN 1
ASUS TUF B360M-PLUS GAMING/BR
CLRTC

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents