Using The Projector; Powering On / Off The Projector - NEC M380HL User Manual

USING THE PROJECTOR

Powering on / off the projector

Powering on
1. Remove the lens cap.
2. Securely connect the power lead and signal/source cable. When connected, the Power LED will turn
red.
3. Turn on the projector by pressing the
remote control.
4. A start up screen will display in approximately 10 seconds and the Power LED will be flashing blue.
Note:
The first time the projector is turned on, you will be prompted to select the preferred language, projection
orientation, and other settings.
Powering off
1. Turn off the projector by pressing the
remote control.
2. The following message will be displayed:
3. Press the
seconds. When you press the
4. The cooling fans will continue to operate for about 10 seconds for the cooling cycle and the Power
LED will flash blue. When the Power turns solid red, this indicates the projector has entered standby
mode. If you wish to turn the projector back on, you must wait until the cooling cycle has finished and
the projector has entered standby mode. When the projector is in standby mode, simply press the
button on the projector keypad or the ON button on the remote control again to turn on the projector.
5. Disconnect the power lead from the electrical outlet and the projector.
Note: It is not recommended that the projector is turned on immediately, right after a power off procedure.
Lens cap
or STANDBY button again to confirm, otherwise the message will disappear after 10
or STANDBY button for the second time, the projector will shut down.
button on the projector keypad or the ON button on the
button on the projector keypad or the STANDBY button on the
Power Off
Power Off?
Press power key again.
or
English
23