Makita GWT04 Instruction Manual page 10

Changing the application mode
This tool employs several easy-to-use application modes for driving bolts with good control.
The type of the application mode changes every time you press the button
You can change the application mode within approximately one minute after releasing the switch trigger.
NOTE: You can extend the time to change the application mode approximately one minute if you press the but-
ton or .
Application mode
(Assist type displayed on panel)
Bolt mode
Bolt mode (1)
Bolt mode (2)
Bolt mode (3)
: The lamp is on.
Feature
Clockwise
This mode helps to repeat screwdriving continuously with
equal torque. This mode also helps to reduce the risk of
breakage of bolts/nuts due to overtightening.
Counterclockwise
This mode helps to prevent a bolt from falling off. When
loosening a bolt with the tool driving in counterclockwise
rotation, the tool automatically stops or slows down after
the bolt/nut gets enough loosened.
NOTE:
The timing to stop the driving varies depending on the
type of the bolt/nut and material to be driven. Make a
test driving before using this mode.
Clockwise
The tool stops automatically as soon as it has started
impact blows.
Counterclockwise
The impact force is 4. The tool stops automatically as soon
as it has stopped impact blows.
Clockwise
The tool stops automatically approximately 0.5 second later
from the moment that the tool has started impact blows.
Counterclockwise
The impact force is 4. The tool stops automatically approx-
imately 0.2 second later from the moment that the tool has
stopped impact blows.
Clockwise
The tool stops automatically approximately 1 second later
from the moment that the tool has started impact blows.
Counterclockwise
The tool slows down the rotation after it has stopped impact
blows.
10 ENGLISH
.
Clockwise
Preventing over
tightening of bolts.
Counterclockwise
Loosening bolts.
Purpose
–
–
–