Comnet NetWave NW1/M Quick Start Manual
  1. Manuals
  2. Brands
  3. Comnet Manuals
  4. Wireless Router
  5. NetWave NW1/M
  6. Quick start manual

Comnet NetWave NW1/M Quick Start Manual

Industrial outdoor 802.11a/n wireless ethernet
Hide thumbs Also See for NetWave NW1/M:
1
2
3
4
5
6
7
8
9
Table of Contents

Advertisement

Quick Links

Download this manual
This manual serves the following
ComNet Model Numbers:
NW1/M
NW2/M
QUICK START GUIDE
INDUSTRIAL OUTDOOR 802.11A/N WIRELESS ETHERNET
Thank you for purchasing NetWave
walk you through installation.
This guide applies to the following models:
NW1/M: Industrial Multipoint, FCC Version, User Configurable
NW2/M: Industrial Multipoint, ETSI Version, User Configurable
An easy to read LED array displays unit operational status along with received signal
strength ensuring optimal installation and operation. See Figure 2 on Page 2 for LED
Indicator explanations.
See Figures 3 through 5 beginning on Page 3 for mounting instructions.
from ComNet. This quick start guide is designed to
®
INS_NW1M_NW2M_QS_REV– 07/7/15 PAGE 1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NetWave NW1/M and is the answer not in the manual?

Questions and answers

Related Manuals for Comnet NetWave NW1/M

Summary of Contents for Comnet NetWave NW1/M

  • Page 1 QUICK START GUIDE INDUSTRIAL OUTDOOR 802.11A/N WIRELESS ETHERNET Thank you for purchasing NetWave from ComNet. This quick start guide is designed to ® This manual serves the following walk you through installation. ComNet Model Numbers: NW1/M This guide applies to the following models:...

  • Page 2: Signal Strength

    QUICK START USER GUIDE NW(1,2)/M FIGURE 1 – MINI INDUSTRIAL WIRELESS ETHERNET LINK FRONT BACK BOTTOM FIGURE 2 – STATUS INDICATING LEDS VISUAL CUE INDICATION SOLID GREEN Power is supplied to the unit POWER No power is supplied to the unit, or the unit is in reset. SOLID GREEN LAN Connected No Connectivity...
  • Page 3 QUICK START USER GUIDE NW(1,2)/M FIGURE 3 – INSTALLATION INSTRUCTIONS Step 1. Unpack the mounting hardware from the box. Determine if this will be a pole or wall mount application. The included Mounting kit is designed to support poles up to 2 in (5.8 cm) in diameter. Step 2.
  • Page 4 QUICK START USER GUIDE NW(1,2)/M FIGURE 4 – POLE MOUNT INSTRUCTIONS Included Hardware Vertical Mount in -45º Position Vertical Mount in +45º Position TECH SUPPORT: 1.888.678.9427 INS_NW1M_NW2M_QS_REV– 07/7/15 PAGE 4...

  • Page 5: Installation Requirements

    • Wireless mode – Set to AP or Client • Country code – Only required if setting up the NW2/M and NWK2/M (ETSI) models NOTE: It is the user’s responsibility to ensure that the correct country is chosen. ComNet accepts no liability for incorrectly set up equipment.

  • Page 6: Reset To Factory Default

    CONFIGURING MAC LOCK FOR POINT TO POINT LINKS MAC-Filter replaces MAC-Lock on the first generation Netwave hardware. MAC-Filter is only available on devices operating as an AP. By default, it is disabled. You can locate MAC-Filter tab by going to Networking -> WIFI -> Enable. To enable and lock to a client radio, Click on the drop down menu and select “Allow Listed Only”.

  • Page 7: Default Configurations

    QUICK START USER GUIDE NW(1,2)/M TYPICAL POINT-TO-POINT CONFIGURATION Cat5 Cable 10/100Mbps or other ComNet Gigabit NW1/M NW1/M PSE device Managed Switch (Set to Access Point) (Set to Client) Camera with 30W PoE+ TYPICAL POINT-TO-MULTIPOINT CONFIGURATION NOTE: NW1/M and NW2/M Multipoint nodes will need to have the Wireless Mode set to either AP or Client (default is Client).

  • Page 8: Agency Compliance

    QUICK START USER GUIDE NW(1,2)/M AGENCY COMPLIANCE Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: •...
  • Page 9 T: +44 (0)113 307 6400 | F: +44 (0)113 253 7462 | INFO-EUROPE@COMNET.NET © 2015 Communications Networks Corporation. All Rights Reserved. “ComNet,” the “ComNet Logo,” “NetWave,” and the “NetWave Logo” are registered trademarks of Communication Networks, LLC. INS_NW1M_NW2M_QS_REV– 07/7/15 PAGE 9...

This manual is also suitable for:

Netwave nw2/m

Table of Contents