Table of Contents
Advertisement
SPLITTING LOGS
See FIGURE 5.
Always place logs lengthwise on the work table and resting
firmly on the side supports with one end against the wedge.
Place logs flat and in the direction of the grain. Never angle
the log to split it or place the log crosswise on the splitter.
Never split more than one log at a time.
•
Place log lengthwise and lying flat on the work
table.
•
Both ends of the log should be cut as square
as possible to help prevent the log from
riding out of the splitter during operation.
•
Do not split logs greater than 20.5 inches
in length.
NOTE: If the log is small, place it against the wedge before
starting the splitter.
TRANSPORTATION
•
This machine can fit in most vehicles for transportation.
•
Ensure that the splitter is properly secured before the vehicle is in motion.
•
Ensure vent plug is tightened, and that all hydraulic fittings are tight to avoid leaking oil.
NOTE:
a)
Never move this machine while the motor is running.
b)
Be extra cautious when moving this machine on rugged and rough terrain.
c)
Store the machine upright so and ensure that it cannot be tipped over during transport.
d)
Never allow anyone to ride on the machine while transporting.
STORAGE
NOTE:
a)
Store this unit switched off and unplugged.
b)
Allow machine to cool 5 minutes after every use before storing.
c)
Protect power supply cable from heat, sunshine, aggressive liquids and sharp edges.
d)
Store unit in a clean, dry area. Do not store in unprotected areas outdoors.
Never place near corrosive materials or in a damp environment.
e)
Do not allow children near the splitter.
Page | 14
WARNING:
Never keep pressure on the wood by trying to force the
log splitter for more than three seconds. After three
seconds, the oil will heat up and could damage the tool.
Advertisement
Table of Contents
