Maintenance Safety - Boss Industrial ED8T20 Owner's Manual

KNOW how to stop the log splitter and disengage the controls before operating it.
NEVER place hands or feet between the log and splitting wedge during forward or reverse stroke. Serious
injury or death could result.
NEVER straddle or step over the log splitter during operation. NEVER reach or bend over the log splitter to
pick up a log. NEVER try to split two logs on top of each other.
NEVER try to cross split a log.
NEVER attempt to load your log splitter when the ram or wedge is in motion.
ALWAYS use your hand to operate the control lever on the valve. NEVER use your foot, a rope or any
extension device.
NEVER move the log splitter while the motor is running. Shut off the motor even if you are leaving the log
splitter for a short period of time.

MAINTENANCE SAFETY

NEVER operate your log splitter when it is in poor mechanical condition or in need of repair. Periodically
check that all nuts, bolts, screws, hydraulic fittings and hose clamps are tight.
NEVER alter your log splitter in any manner under any circumstances. Such alterations may cause your log
splitter to be unsafe and will void the warranty.
ALWAYS unplug from the power source while repairing or adjusting the splitter.
Perform all recommended maintenance procedures before using your log splitter. Replace all damaged or
worn parts immediately.
NEVER tamper with the motor to run it at excessive speeds. The maximum motor speed is preset by the
manufacturer and is within safety limits.
ALWAYS check the level of hydraulic oil before operation.
ALL replacement parts must meet manufacturer's specifications.
Page | 9