Advertisement
Universal Series
MODEL
OD-9005PB | OD-1109PB | OD-1209PB | OD-1505PB
INSTALLATION GUIDE
1. DO NOT use in a cooking area
Types of Typical Installation
1. Housing mounted to I-joists (start at "Assembly Instructions 1" below)
2. Housing mounted to joists (start at "Assembly Instructions 1" below)
3. Housing mounted to truss
(start at step "Assembly Instructions 2" below)
Assembly Instructions
1. Mount Housing to Joist or I-joist
Hold the housing so that it is in contact with the bottom of the joist.
Attach the housing with four (4) screws to joist through the holes in
each mounting flange.
2. Mount with Hanger Bars
a) Sliding hanger bars have been provided, which allow the housing to
be positioned accurately anywhere between the framing. The bars
span up to 24" and can be used on all types of framing: I-joist,
standard joist, and truss construction. Slide hanger bars onto
housing and adjust as needed to fit between framing
b) Extend the hanger bars to the width of the framing. Position the
b)
ventilator with the hanger bar tabs wrapped around the bottom edge
b)
of the framing, holding the ventilator in place.
b)
Secure hanger bars to framing using one screw on each end of
b)
hanger bar. Select a proper hole and secure the hanger bars together
b)
using flange screws.
info@ortechindustries.com
www.ortechindustries.com
2. Two ways to connect ductwork to a factory-shipped unit
13376 Comber Way
375 Admiral Blvd
Mississauga
Surrey BC V3W 5V9
,
ON L5T 2N1
Instruction Manual
1-888-543-6473
1-888-541-6474
Advertisement
