Advertisement
OPERATING INSTRUCTIONS
WARNING:
To reduce the risk of fire or explosion, do not operate this vacuum in areas with flammable gases,
vapors or explosive dust in the air. Flammable gases or vapors include but are not limited to:
lighter fluid, solvent-type cleaners, oil-based paints, gasoline, alcohol or aerosol sprays. Explosive
dusts include but are not limited to: coal, magnesium, aluminum, and grain or gun powder. Do not
vacuum explosive dust, flammable or combustible liquids or hot ashes. Do not use this vacuum as
a sprayer for any flammable or combustible liquid. To reduce the risk of health hazards from vapors
or dusts, do not vacuum toxic materials.
WARNING:
The operation of ash vacuum can result in foreign objects being blown into the eyes, which can
result in severe eye damage. Always wear safety eyewear complying with ANSI Z87.1 or in
Canada, CSA Z94.3 before starting operation.
CAUTION:
To reduce risk of hearing damage, wear ear protectors when using the vac vacuum for extended
hours or when using it in a noisy area.
This 15 liter ash vacuum is assembled at the factory and ready for use when you remove it from the
carton. The unit is ready for dry cold ash vacuuming After you plug the power cord into the wall
receptacle, turn the unit "ON" by pushing the switch from position "O" to position "I". The "O" is the
"OFF" position and the "I" is the "ON" position.
O = OFF I = ON
ASH PICK-UP
The cartridge filter and pre-filter must always be in correct position to reduce the risk of leaks and
possible damage ash vacuum. Make sure that the cartridge filter is completely covering the filter cage.
Make sure there are no gaps between the cartridge filter and the lid. And make sure the pre-filter is
completely covering the opening edge of dust tank. Make sure there are no gaps between the pre-
filter and the dust tank. It is very important to assemble the cartidge filter to the cage and pre-filter
to the dust tank without allowing any possible leaks or tears. Any leaks will allow the picked up
debris to be blown out of the exhausting openings and back into the surrounding environment. And
also damage the motor as well.
NOTE:
The ash vacuum only be used for dry cold ash material. When the filter is wet, the filter will clog
quickly and be very difficult to clean. So if the filter get wet, replace it before continuing to do ash
pickups.
EMPTY THE TANK
WARNING:
To reduce the risk of injury from accidental starting, unplug power cord before emptying the dust tank.
1. R
emove the power head assembly of the ash vacuum by pulling outward on the lid clips located
on
e
a
h c
s
d i
e
f o
2. Dump the tank contents into the proper waste disposal container.
h t
e
a
s
h
v
a
c
u
.
u
m
.
L
t f i
o
f f
h t
e
p
o
w
r e
h
e
a
d
s a
7
e s
m
b
. y l
Advertisement
