Owner Service 15 - Woods Alitec AB720-2, Alitec AB840-2 Operator's Manual

Angle broom
Table of Contents

Advertisement

The information in this section is written for operators
who possess basic mechanical skills. Should you need
help, your dealer has trained service technicians avail-
able. For your protection, read and follow all safety
information in this manual.
Regular preventive maintenance and immediate repair
of broken or worn parts will insure maximum efficiency
and long life.
 Never go underneath equipment (lowered to the
ground or raised) unless it is properly blocked and
secured. Never place any part of the body under-
neath equipment or between moveable parts even
when the engine has been turned off. Hydraulic
system leak down, hydraulic system failures,
mechanical failures, or movement of control levers
can cause equipment to drop or rotate unexpect-
edly and cause severe injury or death. Follow Oper-
ator's Manual instructions for working underneath
and blocking requirements or have work done by a
qualified dealer.
 Before leaving operator's seat, lower lift arms
and put attachment on the ground. Engage brake,
stop engine, remove key, and remove seat belt.
 Do not allow bystanders in the area when oper-
ating, attaching, removing, assembling, or servic-
ing equipment.
 Never perform service or maintenance with
engine running.
 Make sure shields and guards are properly
installed and in good condition. Replace if damaged.
MAN0731 (9/19/2008)
OWNER SERVICE
ARNING
ARNING
 Make sure that all operating and service person-
nel know that if hydraulic fluid penetrates skin, it
must be surgically removed as soon as possible by
a doctor familiar with this form of injury or gan-
grene, serious injury, or death will result. CON-
TACT A P HYS ICI AN I MME DIAT E LY IF FLUID
ENTERS SKIN OR EYES. DO NOT DELAY.
 Make sure all hydraulic hoses, fittings, and
valves are in good condition and not leaking before
starting power unit or using equipment. Check and
route hoses carefully to prevent damage. Hoses
must not be twisted, bent sharply, kinked, frayed,
pinched, or come into contact with any moving
parts. Operate moveable components through full
operational range to check clearances. Replace
any damaged hoses immediately.
 Do not modify or alter or permit anyone else to
modify or alter the equipment or any of its compo-
nents in any way.
 Make sure all safety decals are installed.
Replace if damaged. (See Safety Decals section for
location.)
CAUTION
 Your dealer can supply original equipment
hydraulic accessories and repair parts. Substitute
parts may not meet original equipment specifica-
tions and may be dangerous.
 Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate.

Owner Service 15

Advertisement

Table of Contents
loading

Table of Contents